Centrometal EKO-CK P 35 Kullanım ve Bakım - Sayfa 6
Pelet sobası Centrometal EKO-CK P 35 için çevrimiçi göz atın veya pdf Kullanım ve Bakım indirin. Centrometal EKO-CK P 35 20 sayfaları. Cm pelet-set (14-35 kw)
Sayfayı Yazdır
A flexible tube connecting the pellet burner and pellet tank is made of plastic material reinforced with
metal wire which, in case of back flame from the burner to the tank, melts and prevents flame to
penetrate to the pellet tank.
5. Fuel
Wooden pellets are used as fuel in boilers with built in Cm Pelet-set. Pellets are bio-fuel made of
wooden wastes. Pellets can be stored in different ways: in bags of 15 kg, big bags of 1000 kg and in
bulk form in large tanks (4 to 15 m
pellet properties for firing in Cm Pelet-set:
-
Heating value >= 5 kWh/kg (18 MJ/kg)
-
Diameter = 6 mm
-
Max. length = 50 mm
-
Max. moisture content = 12 %
-
Max. dust content = 1.5 %.
6. Boiler Control Unit
The boiler control unit is supplied in a plasticized metal box prepared for installation on boilers
EKO-CK P (EKO-CK) and EKO-CKB P (EKO-CKB).
6.1 Description of buttons and symbols on the control unit
Button
Safety thermostat button
1
Main switch to turn on/turn off power supply to the control unit
0
Start/stop button (on/Off)
-
-
-
Entry button to the parameter setting menu and going to the next parameter
Setting of the selected parameter to higher value.
Setting of the selected parameter to lower value.
Selection of the WINTER firing regime. In this regime the heating pump turns on and a
sanitary water pump also turns on if a sanitary water sensor is built in.
Selection of the SUMMER firing regime. In this regime only the sanitary water pump
turns on if a sanitary water sensor is built in. If it is a boiler with sanitary hot water
heater inside the boiler water and if no sanitary water sensor is built in, neither the
heating pump nor the sanitary water pump will turn on in the summer regime.
Manual switch on of the pellet feeder. It is used to supply the feeder with pellets (after
tank cleaning, tank discharge...).
3
) dug in soil or located in basement premises. The recommended
By pressing the button for 3 sec. the burner turns on.
While the burner operates, by pressing the button for 3 sec. the burner goes to
extinction phase.
Short pressing of the button: Exit from parameter setting and their saving
Technical instructions Cm Pelet-set
Button function
6