Majestic fireplaces 20010752 Kurulum Talimatları

Şömine Aksesuarları Majestic fireplaces 20010752 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Majestic fireplaces 20010752 4 sayfaları. Fuel conversion kit lp to natural/natural to lp for model dv360

Sayfayı Yazdır

WARNING!

The installation of this conversion kit must only

be undertaken by a qualiﬁed, certiﬁed gas appli-

ance installer.

Tools required for conversion: TORX T20 Security Tee

bit, 3/8", 1/2" deep well socket, Phillips or Robertson

screwdriver, 5/32" Allen wrench.

Check Contents of Shipping Carton

Compare contents of Figure 1 with actual parts re-

ceived. If any parts are missing or damaged, contact

your dealer before starting conversion.

Conversion Precautions

Allow unit to cool if it has been in operation.

Before proceeding, turn control knob on valve to "OFF"

and turn gas supply OFF. Turn OFF any electricity that

may be going to the appliance.

CAUTION: Logs may be HOT! Allow to cool before

proceeding.

Regulator

Dual Spring

Assembly - NG

Dual Spring

Assembly - LP

LP Bracket/

Gasket

Assembly

Fig. 1 Carton contents.

Conversion Instructions

1. Open louvre assembly bottom to gain access to

valve. Remove window frame assembly. (Refer to

Homeowner's Manual)

Fuel Conversion Kit

Installation Instructions

Kits: LP to Natural 20010751

Natural to LP 20010752, 20011025

for Model: DV360

Conversion Label Burner Oriﬁce

(Refer to Table 1

to conﬁrm sizes)

Pilot Oriﬁce

Gasket

Pilot

Oriﬁce

(RF Valve)

Plug -

Red (LP),

Blue (NG)

CAR179

DV360

fuel conversion

2/06 djt

2. Remove logs if previously installed.

Honeywell Valve

1. Remove cap from HI/LO knob. This can be accom-

plished by lifting the plastic cap off the screw. (Fig. 2)

2. Remove the screw from center of HI/LO knob with

small screwdriver turning counterclockwise. (Fig. 2)

Cap

Lift Open

Hi/Lo

Knob

Fig. 2 Remove center screw from Hi/Lo knob.

3. Insert conversion screw supplied in conversion kit.

Blue for natural gas, red for LP.

4. Tighten screw, replace cap.

NOVA SIT820 Valve

1. Using the TORX T20 bit, remove and discard the

three (3) pressure regulator mounting screws (A),

pressure regulator tower (B) and the spring and

diaphragm assembly (C). (Fig. 3)

Fig. 3 Remove mounting screws, pressure regulator tower

and spring and diaphragm assembly.

Remove Center Screw

CO100

Gas conversion

HI-LO knob

3/15/99 djt

FC107

20010843 3/08 Rev. 4

FC107

SIT820

valve conversion

10/03

CO100