Gamma 5002 Kullanıcı El Kitabı - Sayfa 14

Tel Çekme Makineleri Gamma 5002 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Gamma 5002 18 sayfaları.

MAINTENANCE

Tension Calibration Procedure

Step 1

Set the tension to 60 lbs. as indicated by the

linear scale and rotary knob. Place the string

on one end of a tension calibrator into a string

clamp and secure. Place string located on

the other end of the calibrator into the string

tensioner and apply tension. If the brake

lever releases before 60 lbs. or after 60 lbs.,

the tension head should be calibrated as

follows.

Tension Calibration Procedure

Step 2

Loosen the plastic locking screw (A) located

on the side of the latching block as shown.

The plastic screw is used to hold the adjust-

ment screw in place.

Tension Calibration Procedure

Step 3

If the lever releases before 60 lbs., using the

supplied L-shaped hex wrench, turn the

adjustment screw (B) located on the left side

of the latch block counter-clockwise to in-

crease the engagement of the brake release

latch with the brake lever. Repeat step 1 and

adjust until the correct tension is indicated on

the calibrator.

If the tension indicated in step 1 is greater

than 60 lbs., turn the adjustment screw clock-

wise to reduce the engagement of the brake

release latch with the brake lever. Repeat

step 1 and adjust until the correct tension is

indicated on the calibrator.