Gamma 5003 Kullanıcı El Kitabı - Sayfa 14

Tel Çekme Makineleri Gamma 5003 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Gamma 5003 20 sayfaları. 6 point mounting
Ayrıca Gamma 5003 için: Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (19 sayfalar), Kullanıcı El Kitabı (20 sayfalar)

Sayfayı Yazdır

MAINTENANCE & ADJUSTMENT

Tension Calibration Procedure

Set the tension to 60 lbs. as indicated by the

linear scale and rotary knob. Place the string

on one end of a tension calibrator into a string

clamp and secure. Place string located on

the other end of the calibrator into the string

tensioner and apply tension. If the brake lever

releases before or after 60 lbs., the tension

head should be calibrated as follows.

Loosen the 1.5 mm locking set screw (A)

located on the side of the latching block as

shown. The set screw is used to hold the

adjustment screw in place.

If the lever releases before 60 lbs., using

the supplied L-shaped hex wrench, turn

the adjustment screw (B) located on the left

side of the latch block counter-clockwise to

increase the engagement of the brake release

latch with the brake lever. Repeat step 1 and

adjust until the correct tension is indicated

on the calibrator.

If the tension indicated in step 1 is greater

than 60 lbs., turn the adjustment screw clock-

wise to reduce the engagement of the brake

release latch with the brake lever. Repeat

step 1 and adjust until the correct tension is

indicated on the calibrator.

Tighten locking set screw (A) when finished.