Gamma Progression 600FC Kullanıcı El Kitabı - Sayfa 12
Tel Çekme Makineleri Gamma Progression 600FC için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Gamma Progression 600FC 15 sayfaları.
Your GAMMA 600 stringing machine is adjusted for optimum performance at the factory and
needs no further adjustments before use. After extensive use however, the machine may
need minor adjusments as follows :
damages the string, it is too tight and must be adjusted by turning the thumb knob or hex screw
counterclockwise.
The clamp jaws must be clean and free from dirt, oil, and any string coating for them to grip
properly. Clean the clamp jaws with alcohol.
Note: The string clamps supplied with your Gamma stringing machine can accomodate
tight string patterns such as badminton. Depending on the string pattern, the clamp
will spread the strings slightly which will not compromise the quality of the string
job.
MAINTENANCE
Adjusting the Turntable Bushings
There are two adjustment points on the
machine base. One is located beneath the
polystyrene base cover while the other is
accessed from below the machine.
Using the supplied 3mm hex wrench, tighten
both set screws slightly until the turntable
rotates smoothly without excessive free
play.
Repeat procedure until final adjustment is
reached.
Adjusting the Clamps
The clamps provided with your stringing
machine will need minor adjustments ac-
cording to what string type, construction,
and gauge you are using.
To adjust, route the string through the racquet
as if you were beginning the main strings.
Clamp the strings and pull tension. If the
string slips through the jaws of the clamp,
tighten the clamp by turning the thumb knob
(floating clamp) or hex screw (fixed clamp)
opposite of the handle, in the clockwise
direction. If the clamp leaves impressions or
11