Gamma PROGRESSION 602 Kullanıcı El Kitabı - Sayfa 4

Tel Çekme Makineleri Gamma PROGRESSION 602 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Gamma PROGRESSION 602 12 sayfaları.
Ayrıca Gamma PROGRESSION 602 için: Kullanıcı El Kitabı (16 sayfalar)

Gamma PROGRESSION 602 Kullanıcı El Kitabı

ASSEMBLY INSTRUCTIONS

Engaging the Drop Weight Bar Stop
The stringing machine is shipped with the drop weight
bar in the horizontal position. To prevent racquet
damage during stringing, the bar stop must be engaged.
Remove the machine base from the shipping carton
being careful to avoid lifting by the plastic cover.
Hold the drop weight bar in the vertical position as shown
while turning the stop screw clockwise with the supplied
5mm hex wrench.
Installing the Turntable
Remove the turntable from the foam packing of the
shipping carton. Insert the center post of the turntable
into the bushing of the stringing machine base.
Installing the Frame Support Posts
The Progression 602 support post assemblies are pre-
cision aligned at the factory and are marked for proper
installation on the turntable.
Install the support post with the dot on its base to an
identical dot on the turntable. Align the threaded hole in
the bottom of the frame support post with the slot in the
turntable. Screw the lever lock bolt with washer into the
bottom of the support post and tighten gently.Position
the washer the rounded side toward the turntable.
Repeat procedure on the opposite side of the turntable
3