Gamma Progression 602 FC Kullanıcı El Kitabı - Sayfa 12
Tel Çekme Makineleri Gamma Progression 602 FC için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Gamma Progression 602 FC 16 sayfaları.
Ayrıca Gamma Progression 602 FC için: Kullanıcı El Kitabı (16 sayfalar)
Sayfayı Yazdır
MAINTENANCE & ADJUSTMENTS
hex screw counter clockwise to open the gap between the jaws. The clamp jaws should be
cleaned periodically to be free from dirt, oil, and any string coating for them to grip properly.
Note: The string clamps supplied with your stringing machine can accommodate tight string
patterns such as badminton. Depending on the string pattern, the clamp may spread the
strings slightly which will not compromise the quality of the string job.
Adjusting the Turntable Bushings
The turntable bushing is adjusted at the fac-
tory for optimum performance. After time and
use, the turntable bushings may need minor
adjustment. An adjustment is indicated when
noticeable turntable looseness or wobble
occurs while stringing.
To adjust the fit between the turntable pin
and the bushings, tighten the set screw at the
top of the bushing using a 3mm hex wrench.
Adjusting the Clamp Pressure
The clamps provided with your stringing ma-
chine will need minor adjustments according
to what string type, construction, and gauge
you are using.
To adjust the gap (clamping pressure)
between the clamp jaws, insert the string
through the racquet as if you were beginning
Adjustment
Knob
the main strings. Clamp the strings and pull
tension. If the string slips through the jaws of
the clamp, tighten the clamp by compress-
ing the clamp jaws together by hand while
turning the Adjustment Knob, in the clockwise
direction. If the clamp leaves impressions or
damages the string, it may be excessively
tight and should be adjusted by turning the
Clamp Base Locking Nut Adjustment
In the event the Locking Lever rotation is
insufficient to ensure smooth operation of the
clamp base, very minor adjustments to the
Clamp Base Locking Nut can be made with
the supplied 17mm socket. Tighten or loosen
the locking nut in very small increments to
provide more clamping pressure or running
clearance as needed.
12