Gamma X-6FC Kullanıcı El Kitabı - Sayfa 15

Tel Çekme Makineleri Gamma X-6FC için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Gamma X-6FC 20 sayfaları.
Ayrıca Gamma X-6FC için: Kullanıcı El Kitabı (20 sayfalar)

Sayfayı Yazdır

MAINTENANCE & ADJUSTMENTS

The clamp jaws must be clean and free from dirt, oil, and any string coating for them to grip

properly. Clean the clamp jaws with alcohol.

Note: The string clamps supplied with your stringing machine can accommodate tight string

patterns such as badminton. Depending on the string pattern, the clamp will spread the strings

slightly which will not compromise the quality of the string job.

Adjustment

Knob

Turntable Bushing Adjustment

The turntable bushing is adjusted at the fac-

tory for optimum performance. After time and

use, the turntable bushings may need minor

adjustment. An adjustment is indicated when

noticeable turntable looseness or wobble

occurs while stringing.

To adjust the fit between the turntable pin

and the bushings, tighten the set screw at the

top of the bushing using a 3mm hex wrench.

Tighten until the turntable rotates smoothly

without excessive free play.

Adjusting the Clamps

The clamps provided with your stringing

machine will need minor adjustments accord-

ing to string type, construction, and gauge.

To adjust, route the string through the racquet

as if you were beginning the main strings.

Clamp the strings and pull tension. If the

string slips through the jaws of the clamp,

tighten the clamp by turning the adjustment

knob opposite of the handle, in the clockwise

direction. If the clamp leaves impressions or

damages the string, it is too tight and must

be adjusted by turning the adjustment knob

counterclockwise.

Clamp Base Locking Nut Adjustment

In the event the Locking Lever rotation is

insufficient to ensure smooth operation of the

clamp base, very minor adjustments to the

Clamp Base Locking Nut can be made with

the supplied 17mm socket. Tighten or loosen

the locking nut in very small increments to

provide more clamping pressure or running

clearance as needed.