Gamma X-ST Kullanıcı El Kitabı - Sayfa 4

Tel Çekme Makineleri Gamma X-ST için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Gamma X-ST 19 sayfaları.
Ayrıca Gamma X-ST için: Kullanıcı El Kitabı (19 sayfalar), Kullanıcı El Kitabı (19 sayfalar)

Sayfayı Yazdır

ASSEMBLY INSTRUCTIONS

Remove and Discard Plastic Washers

Winder Bar Installation

To install the winder bar, slide over the post

on the base and secure it with the 2 allen

set screws.

Note: When purchased with the optional ﬂ oor

stand, it is most convenient to attach the base

to the ﬂ oor stand at this point. See instruc-

tions provided with the optional ﬂ oor stand.

Turntable Installation

To install the turntable, position it over the

turntable pin and align the bolts (included in

separate bag) with the holes in the ﬂ ange.

Secure them with the included 6mm allen

wrench.

Note: When purchased with the optional ﬂ oor

stand, it is most convenient to attach the base

to the ﬂ oor stand at this point. See instruc-

tions provided with the optional ﬂ oor stand.

Support Post Installation

To install the support posts you must ﬁ rst

remove the mounting bolt from the mounting

plate that sets inside the central cavity of the

turntable. There are large holes stamped on

the underside of the turntable that allow you to

support the mounting plate with your ﬁ ngers

while removing the mounting bolt.

After removing the mounting bolt, remove

and discard the plastic washers that are

installed for shipping purposes.