Gamma Oculus 40 Kullanıcı Kılavuzu - Sayfa 7

Aydınlatma Ekipmanları Gamma Oculus 40 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Gamma Oculus 40 12 sayfaları. 12x40w rgbw led wash with pixel mapping

Sayfayı Yazdır

32 Fixture Rule – DMX only allows you to connect up to 32 fixtures in a single daisy

chain for signal strength. Sometimes, depending on the fixtures and cable length, this

number is less (or more).

DMX Cables can be 3-pin or 5-pin. These use the same type of data, and in the 5-pin

only pins 1, 2, and 3 are used. The cable should be a 2 conductor, shielded cable of at

least 110 ohms resistance. Microphone cable is not DMX cable.

Please refer to the diagram below:

For installations where the DMX cable has to run a long distance or is in an electrically

noisy environment, it is recommended to use a DMX terminator. This helps in preventing

corruption of the digital control signal by electrical noise and reflections. The DMX

terminator is simply an XLR plug with a 120 Ω resistor connected between pins 2 and 3,

which is then plugged into the output XLR socket of the last fixture in the chain. Please

see illustrations below:

Oculus 40 – GAMMA LED Vision

Page 7 of 12