IKEA SKYTTA Kurulum Kılavuzu - Sayfa 8

İç Mekan Mobilyaları IKEA SKYTTA için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. IKEA SKYTTA 16 sayfaları.
Ayrıca IKEA SKYTTA için: Kurulum Kılavuzu (16 sayfalar)

Sayfayı Yazdır

1. Height Options

To think about

Here are some general tips to have in mind before you

start assembling SKYTTA sliding doors. These tips are for

all the solutions, and for more specific tips depending on

Floor rail

The floor rail is provided with double sided tape which works on solid flooring.

Avoid using the floor rail on rugs, as it will not stay fixed properly. The system can be

adjusted if the floor is uneven (0-2 mm/1/8" per 1 m/393/8"). The floor rail has a front side

so make sure it is positioned correctly. If you are connecting two floor rails, make sure

the cut end is facing the wall.

Wood beam

Since your ceiling will support the weight of your sliding door, start by finding safe

fixing points for the wood beam. If you are connecting two wood beams, make sure

that the front sides are in line with each other. A flange screw is pre-mounted in every

second hole. In some cases when you have cut the desired length, you need to move

one flange screw so there is one on each side of the aluminum rail joint. The wood

beam has a front side on the 3-track rail but is the same front and back on the 2-track.

You will need to purchase the proper screws for this installation, as these are not

included by IKEA.

Ceiling rail

The ceiling rail can stay temporarily in place with screws, but we recommend that you

continue to hold it during installation. Screws should be mounted from below and from

the front, spaced evenly in at least every second hole. The ceiling rail has a frontside on

the 3-track rail but is the same front and back on the 2-track. If you are connecting two

ceiling rails, make sure the cut end is towards the wall. The rails need to be aligned so

be careful when tightening the screws close to the joint(s) of the rail.

the solution that is applicable to your room, please see the

following pages and the Assembly Instructions.

Stop bar

The wall or the stop bar will be the closing surface for the sliding door. In both

alternatives it is important to have a straight and levelled closing surface. The system

can be adjusted if the wall is uneven (0-3 mm/1/8" per 1 m/393/8").

Adjust flange screw

In the Assemble Instructions you will find the H measurement between the top of the

floor rail to the flange on the flange screw. We recommend using the top cover as a

ruler for the fine tuning to align them.

Soft close

The soft close and soft-closing activators must be mounted into the rail before the last

ceiling rail is mounted. You need to place the parts according to your layout from the

planning tool. The doors placed closest to the wall have two soft-closing mechanisms

and end activators. Doors in the middle have one soft closing mechanism and one end

activator.