JAKO CER-285 Kurulum Kılavuzu - Sayfa 2

Kilitler tarafından JAKO CER-285 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. JAKO CER-285 2 sayfaları. Deadbolts, for single cylinder / for double cylinder

Sayfayı Yazdır

INSTALL EXTERIOR MECHANISM

For right doors, take the outer cylinder with the platen

(knob) facing you and turn it clockwise (right) until it stops

and is horizontal. Then insert it through the slot in the latch.

For left door, take the cylinder in the same direction, but turn

the plate counterclockwise (left).

Doorknob slot

Cylinder platen (control).

INSTALL THE RECEIVER

Close the door and with the help of the latch mark its

position in the door frame.

Mark the center of the 25mm hole and the location of

the screws. Make a 3mm deep box and then drill the

25mm hole. Then place the receiver and tighten.

Receiver

Door edge line.

MARK THE CENTER

OF THE DOOR

EDGE.

BEND HERE

OVER THE

EDGE OF THE

DOOR.

www.jakohardware.com

INSTALL THE LATCH

For a single cylinder.

Insert the screws and secure them.

For double cylinder

Position the cylinder platen (knob) vertically and insert

it through the slot in the latch. Insert the screws and

secure them

For a single cylinder

ADJUSTABLE LATCH INSTRUCTIONS

Hold the frontal and with the other hand turn the lock

case 1/4 of turn, then retract or pull it according to the

case until the pin is located again.

60mm.

70mm.

For double cylinder

Case

Frontal

60mm (2-3/8")

54mm

2-1/8"

70mm (2-3/4")