Gamma Scale GMC-230 Kullanım Kılavuzu - Sayfa 5

Terazi Gamma Scale GMC-230 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Gamma Scale GMC-230 6 sayfaları. Digital desktop weighing scale

be switched off and the relevant cursor will disappear.
Note: No matter whether its backlight function has been switched on or not, the
backlight will automatically switch on about 1 second once powered on.
5.7 Auto Shut-off
If this function enabled, the scale will automatically shut off in 4 minutes after
operation stop, at this time the indicating cursor "Auto Off" will appear. The result of
auto shut-off is the same with pressing [OFF].
Prompt: The meaning for operation stop is that all the operation keys are not operated
when the scale is remained at zero position.
5.8 RS-232C output
The scale transmits RS-232C signal in continuous mode by MCS-51 way 1, the data
to be sent is ASCII code, every group has 16 frames including I frame of start character
(02), 2 frames of state mark, I frame of empty case character, 6 frames of displaying data
and 6 frames of tare data. Every frame consists of 10 digits. The first is start bit, "0". The
tenth is stop bit, "1". The other eight are data bits (from low to high), the patterns is as
follows:
Start Bit
D0 D1 D2 D3 D4 D5 D6 D7 Stop Bit
Note: The Baud rate for its data output is usually set at t200 when the scale leaves
the company, and you may amend the Baud rate in calibrating state according to your
need.

6. Storage Battery Maintenance

6.1 When the low voltage indicate light appears, it means the battery voltage is too low
for the scale to work normally. At this time, charge the battery. With AC power, charge
can be processed while operating. If do not charge the low voltage battery in time, and
continue to operate it, the scale will be forced to shut off in several minutes.
6.2 If it automatically shut off as soon as DC power turns on, it means its battery voltage
is too low, at this time, charge the battery at once.
6.3 If the working time of storage battery is rather short than fully charged, it is
recommended to change the storage battery. Open the battery box cover, pulling up the
positive and negative metal pieces and removing the old storage battery. While opening
the cover, be careful to make sure the battery will not drop. Be sure of correct connection
of the storage battery's electrode.
6.4 If the scale is not used for a long time, be sure that the storage battery is in power-off
status.
- 4 -