IKEA UPPSPEL Talimatlar Kılavuzu - Sayfa 7

İç Mekan Mobilyaları IKEA UPPSPEL için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. IKEA UPPSPEL 17 sayfaları. Gaming desks
Ayrıca IKEA UPPSPEL için: Manuel (11 sayfalar), Hızlı Başlangıç Kılavuzu (5 sayfalar)

Sayfayı Yazdır

1. Troubleshooting Guide

Reset process:

Step 1: Press/hold the

the table reaches

Step 2: Press/hold the

display shows "RST".

Step 3: Press/hold the

table slowly lowers. Once the table stops moving and the

display shows "72", your desk is ready to use.

Lock/Unlock controller:

Lock the controller: Press and hold the

seconds until the display shows "LOC".

Unlock the controller: Press and hold the

seconds until the display shows the actual height of the table.

Error Code Instructions

Error Code Reason

E01

Overcurrent protection/short circuit

E07

Motor line open circuit error

H01

Over-heating

RST

Power failure

888/000

Controller error

This device complies with Part 15 of the FCC Rules.

This device contains licence-exempt transmitter(s)/receiver(s) that

comply with Innovation Science and Economic Development Canada's

licence-exempt RSS standard(s).

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interfer-

ence that may cause undesired operation of the device.

WARNING:

Any changes or modifications to this unit not expressly

approved by the party responsible for compliance could void

the user's authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation.

This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

quipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and

receiver.

down button for a few seconds until

its lowest position.

down button a second time until the

down button a third time until the

symbol for 10

Solution

See instructions for Reset/Initialisation.

Unplug from the wall socket and re-plug – or wait 18

minutes to let the motors cool before using them again.

See instructions for Reset/Initialisation.

Please contact IKEA Customer Service.

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for

help.

The crossed-out wheeled bin symbol indicates that the item

should be disposed of separately from household waste. The

item should be handed in for recycling in accordance with local

environmental regulations for waste disposal. By separating a

marked item from household waste, you will help reduce the

volume of waste sent to incinerators or land-fills and minimise

any potential negative impact on human health and the

environment. For more information, please contact your IKEA

store.