Green Brook ODM201 Manuel

Güvenlik Sensörleri Green Brook ODM201 için çevrimiçi göz atın veya pdf Manuel indirin. Green Brook ODM201 2 sayfaları. Infra-red microwave presence detector- adjustable

Sayfayı Yazdır

Infra-red Microwave Presence Detector- Adjustable

•

Please read these instructions carefully before installation and keep safe for future

reference.

IMPORTANT

This product should be installed by a competent person and in accordance with the

current IET Wiring Regulations and Building Regulations.

If in doubt,consult a qualified electrician.

•

Always turn off the mains supply before commencing work.

Switch the mains supply OFF first to prevent electric shock.

Decide on mounting position of sensor

in and screw into position using the two

mounting lugs at either end. (ensure there

is no wiring/gas/water services directly

behind the screws) refer to Dia:1.

Dia:1

Note:

www.greenbrook.co.uk for wiring sensor in parallel.

1. Turn 'Time' control fully anti-clockwise, 'Lux' control fully clock wise and 'Sens' control fully

clockwise refer to Dia:3.

Dia:3

2. Re-connect mains supply, allow 30 seconds for the sensor to warm-up, and then per

form a walk-by in front of the sensor; lamp should turn on and stay on for

approximately 10 seconds, and will go off if no further movement is detected.

'Orion Range'

Model: ODM201

Important Safety Instructions

INSTALLATION

Dia:2

Please refer to Data Sheet on the GreenBrook website -

Connect the mains in and load out wires

according to Dia:2.

TESTING