Gamma Sports STII Kullanıcı El Kitabı - Sayfa 10

Tel Çekme Makineleri Gamma Sports STII için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Gamma Sports STII 10 sayfaları.

Sayfayı Yazdır

STRINGING THE FRAME

until the "1" or "2" mark on the knob aligns with the line on the knob support. To decrease

tension by 1 or 2 lbs., turn the knob clockwise until the "2" or "1" mark on the knob aligns with

the line on the knob support.

Travel Stop

Setting Tension

The STII utilizes a rotary adjusting knob

along with a linear tension scale to indicate

the tension setting. The scale is divided into

3 lb. increments and each 1/3 turn of the ten-

sion knob changes tension by 1 lb. To set the

desired tension, rotate the tension knob and

align the mark on the spring guide with the

desired tension setting on the scale. When

the "0" mark on the knob aligns with the line

on the knob support the tension will be that

indicated on the scale. To increase tension

by 1 or 2 lbs. turn the knob counterclockwise

Tensioner Travel Stop

The tensioner bar is equipped with a tensioner

travel stop to limit travel of the tensioner along

the bar and prevent contact between the

tensioner and the racquet mounting system

while stringing. The travel stop is located

about midpoint along the tensioner bar below

the gear track.

To disengage the stop, pull and hold the knob,

rotate 90 degrees and release. To engage the

stop, repeat the above procedure until the

travel stop pin protrudes beyond the opposite

surface of the tensioner bar.

Setting the Gripper Jaw Spacing

The gripper jaws of the tensioner are adjust-

able to accommodate varying string gauges.

If the string slips through the gripper jaws

while pulling tension, rotate the gripper jaw

adjustment screw counter-clockwise.

If the string is damaged while pulling tension,

rotate the gripper jaw adjustment screw

clockwise.

The jaws will be properly adjusted when

there is enough pressure to securely grip the

string without causing damage to the string.

STRINGING THE FRAME

manufacturers recommendations.

Pulling Tension

Wrap the loose section of string once around

the roller guide and insert the string between the

diamond dust coated string gripper plates. Pull

the string perpendicular to the gripper plates while

slowly rotating the tensioner crank clockwise until

the brake lever pops out of the latching block. The

string is now tensioned and can be clamped in place

with the remaining ﬁ xed clamp.

Repeat the above steps until all main strings are

installed. Tie off ends of main strings as per racquet

Weaving the Cross Strings

Weave the cross strings over and under the

main strings being careful to alternate the

weave direction of each consecutive cross

string so as to be opposite of the previously

installed cross string.

Once the ﬁ nal cross string is tensioned and

clamped, tie off at the appropriate hole speci-

ﬁ ed by the racquet manufacturer.