Deck Masters EDGEfast Kullanım Talimatları - Sayfa 4

Elektrikli El Aletleri Deck Masters EDGEfast için çevrimiçi göz atın veya pdf Kullanım Talimatları indirin. Deck Masters EDGEfast 4 sayfaları. Hidden fastener decking system

Sayfayı Yazdır

Always check with decking manufacturer for proper gaping between deck boards, and at ends. Composites

and other plastics will move with the change in temperature. The longer the piece, the more it will expand

and contract.

Wood decking will expand and contract due to moisture, always check manufacturer's requirements.

Tool tips ,

Oil the tool daily, 3 to 5 drops.

WARNING!

Never point the tool at anyone, or at anything other than a surface to be fastened.

Do not leave the tool unattended with the air connected.

There should be no people or valuables under a deck that you are working on.

WARNING!

Read Operating Instructions

Always become familiar with all the instructions and warnings before operating any power tool.

Always wear approved eye protection

Impact resistant eye protection should meet or exceed the standards as set forth in the United States ANSI

Z87.1,

Safety Instructions

The instructions are furnished as general guidelines for use of your pneumatic tool.

When operating pneumatic tools it is of the utmost importance to think safety first. Disconnect tools

from the air supply when changing accessories or when the tool is not in use. Use eye protection.

Putting a few drops of air tool oil in the tool and running for a few seconds at the end of a day will help

protect internal parts. Follow all operating instructions and operate tool in accordance with the ANSI

B186.1 safe operating code.

Tool Application and Usage

Portable tools shall be used only for the purposes intended in their design and within the capacity for

which they were intended and rated. It shall be the tool owner's and/or employer's responsibility to

instruct each operator in the safe use of the tool.

Tool Maintenance

It shall be the tool owner's and/or employer's responsibility to assure that tools are maintained in a

safe operation condition. Tool maintenance and repair shall be performed by authorized, trained,

competent personnel.

Quick reference for psi settings needed in different material,

in some cases more or less may be required.

Cedar

Mahogany

Redwood

PVC

Cypress

Pressure Treated

Fir

(100 to 110)

(70 to 90)

Trouble shooting,

Fastener not driven fully,

Fastener is set to deep,

Fastener angle is not correct,

Fastener to low on the edge,

Fastener is too high on the edge,

Fastener dose not fire,

Composite

Hardwood

Not recommended

Not recommened

unless grooved for

EDGEfast. If so,

(100 to 110)

raise the psi,

decking is too hard,

lower psi

make sure the pivot arch has full motion to stops.

does pivot move to stop, decking may be too hard.

does pivot reach its stop, go to wider gap spacer plate.

check magazine for blockage, check clips for flatness

and angle alignment,

are fasteners free to advance forward, is air supply

connected, are fasteners loaded, is the dry fire lockout

engaged (if so load more fasteners). Can't find

the problem call for service