Major tech MT785 Manuel - Sayfa 4

Ölçüm Cihazları Major tech MT785 için çevrimiçi göz atın veya pdf Manuel indirin. Major tech MT785 20 sayfaları. 1000 a ac/dc trms power clamp meter true rms
Ayrıca Major tech MT785 için: Kullanıcı Kılavuzu (7 sayfalar)

Sayfayı Yazdır

1. Safety

1.1. International Safety Symbols

1.2. Safety Notes

Do not exceed the maximum allowable input range of any function.

Do not apply voltage to meter when resistance function is selected.

Set the function switch OFF when the meter is not in use.

Remove the battery if meter is to be stored for longer than 60 days.

1.3. Warnings

Set function switch to the appropriate position before measuring.

When measuring volts do not switch to current/resistance modes.

Do not measure current on a circuit whose voltage exceeds 600V.

When changing ranges always disconnect the test leads from the

circuit under test.

1.4. Cautions

Improper use of this meter can cause damage, shock, injury or death.

Read and understand this user manual before operating the meter.

Always remove the test leads before replacing the battery or fuses.

Inspect the condition of the test leads and the meter itself for any

damage before operating the meter. Repair or replace any damage

before use.

Use great care when making measurements if the voltages are

greater than 25VAC RMS or 35VDC. These voltages are considered a

shock hazard.

Always discharge capacitors and remove power from the device under

test before performing Diode, Resistance or Continuity tests.

This symbol adjacent to another symbol, terminal or

operating device indicates that the operator must

refer to an explanation in the Operating Instructions

to avoid personal injury or damage to the meter.

This symbol adjacent to one or more terminals

identiﬁes them as being associated with ranges that

may, in normal use, be subjected to particularly

hazardous voltages. For maximum safety, the meter

and its test leads should not be handled when these

terminals are energized.

Equipment is protected by double or reinforced

insulation