Decko 24000-DKO Kullanıcı El Kitabı - Sayfa 6

Garaj Kapısı Açıcı Decko 24000-DKO için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Decko 24000-DKO 14 sayfaları. Handles doors 18 ft. wide & up to 7ft.tall

Sayfayı Yazdır
Installing Cable and Chain
!
To prevent SERIOUS INJURY:
- DO NOT connect power until instructed.
- Keep hands and fingers clear from sprocket during operation.
- Wear gloves when installing chain and cable.
- Keep hands and fingers away from joints and possible sharp edges.
Cable
Rail Bracket
Sprocket
Chain
Rail Bracket
Chain in RED
Sprocket
Fig.1
To Connect and Tighten the Chain:
1
Spring Clip
Link Cap
Open end of chain
Cable Eyelet
Master Link
2
Chain to Cable Connector
Tighten until...
3
Flange Nut
Tighten nut
Fig.2
6
WARNING
To Install Chain
1.
Pull the remaining chain along the rail toward the Opener.
2.
A segment of chain marked in RED will be seen. Place this
segment in the approximate location on the sprocket as
shown in Fig.1.
3.
When the chain is aligned properly around the sprocket, pull
the Chain-to-Cable Connector towards the Trolley Shaft.
Follow steps shown in Fig.2 to connect & tighten the chain:
1.
Align the open end of the chain to the Cable Eyelet and
connect together using the Master Link Set.
2.
Turn the Chain-to-Cable Connector on the Trolley Shaft
until the chain is about 1/4" (6mm) above the base of the
rail. Compare with the illustration below.
3.
Tighten the Flange Nut on Trolley Shaft against the Chain-to
-Cable Connector.
When the chain and cable are tightened around the rail and
sprocket on the Opener, check and make sure the chain is
properly aligned and not twisted. Attach the Sprocket Cover to
the Opener as shown in Fig.3.
Notice
During operation, it is normal for the chain to appear loose when
the door is closed. If the chain returns to the position as shown
below when the door is opened, the chain is adjusted properly.
DO NOT re-tighten the chain.
When performing maintenance, always PULL the Emergency
Release to DISCONNECT the door from Opener before adjusting
the chain.
Mid-point of rail assembly
Top of Rail
Actual Size
1/4" (6mm)
Base of Rail
Fig.3
Repair Parts

Rail Assembly Parts

1
2
3
4
5
7

Installation Parts

1
4
Accessories
Chain
Sprocket
Cover
1
Item
1
2
3
4
6
5
6
7
8
8
Item
1
2
3
2
3
5
6
7
4
5
6
7
Item
1
2
3
2
3
4
4
5
5
Part No.
Name / Description
24911
Rail—Header Segment
24909
Rail—Middle segment
24910
Rail—End segment with Stop Bolt
24929
Pulley
24927
Trolley
24928
Trolley Shaft and Cable
24907
Master Link Set
24908
Chain
Part No.
Name / Description
24919
Header Bracket
24917
Door Bracket
Hardware Bag
24925
(Installation hardware shown on P.3)
24921
Curved Door Arm
24923
Straight Door Arm
24924
Emergency Release Knob & Rope
24941
Hanging Bracket
Part No.
Name / Description
Photo Eye Safety System
24913
(Emitter + Sensor with Brackets)
24915
Wall Panel
24111
Hand-held Transmitter
24939
12V alkaline battery
24000-M
Owner's manual
23