IKEA HYLLAD Manuel - Sayfa 16

Fırın IKEA HYLLAD için çevrimiçi göz atın veya pdf Manuel indirin. IKEA HYLLAD 48 sayfaları. Ikea oven
Ayrıca IKEA HYLLAD için: Kullanıcı Kılavuzu (28 sayfalar)

Sayfayı Yazdır

ENGLISH

• To clean metal surfaces use a usual

cleaning agent.

• Clean the oven interior after each use.

Then you can remove dirt more easily

and it does not burn on.

• Clean stubborn dirt with a special oven

cleaner.

• Clean all oven accessories after each use

and let them dry. Use a soft cloth with

warm water and a cleaning agent.

• If you have nonstick accessories, do not

clean them using aggressive agents,

sharp-edged objects or a dishwasher. It

can destroy nonstick coating.

Stainless steel or aluminium applian-

ces:

Clean the oven door with a wet sponge on-

ly. Dry it with a soft cloth.

Do not use steel wool, acids or abrasive

materials, as they can cause damage to the

oven surface. Clean the oven control panel

with the same precautions.

Shelf supports

You can remove the shelf supports to clean

the side walls.

Removing the shelf supports

Pull the front of the

shelf support away

from the side wall.

Installing the shelf supports

Install the shelf supports in the opposite se-

quence.

The rounded ends of the shelf supports

must point to the front.

Pull the rear end of

the shelf support

away from the side

wall and remove it.

Pyrolysis

Warning! The appliance becomes very

hot. There is a risk of burns.

Caution! If a hob is installed with the

appliance, do not use it at the same

times as the Pyrolysis function. It can cause

damage to the appliance.

1. Remove the removable shelf supports (if

applicable) and accessories from the

appliance. Refer to "Removing the shelf

supports".

Caution! Do not let the removable

shelf supports stay in the appliance

during the cleaning procedure. There is a

risk of damage.

2. Remove the worst dirt manually.

3. Fully close the oven door.

The cleaning procedure cannot start if

you do not close the oven door.

4. Set the function Pyrolysis. Refer to

"Oven functions".

5. When the display shows P1, press

start the procedure. You can use the

End function to delay the start of the

cleaning.

Pyrolytic procedure takes 2 hours.

Do not open the door before the

procedure completes. This will

abort the procedure. To prevent risk of

burns when the oven reaches a certain tem-

perature the door automatically locks. The

display shows the symbol

oven cools down, the door automatically

unlocks.

To stop Pyrolysis before it is comple-

ted, turn the knob for the oven func-

tions to the off position.

When Pyrolysis is completed, the display

shows the time of day. The oven door stays

locked. When the appliance is cool again,

an acoustic signal sounds and the door un-

locks.

During the Pyrolysis the oven lamp is

off.

. When the