Airflow LA COSTA Kullanıcı El Kitabı - Sayfa 5

Fan Airflow LA COSTA için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Airflow LA COSTA 12 sayfaları. Fans

Sayfayı Yazdır

1. Troubleshooting

Step 3. Position the switch housing assembly on the

switch housing plate and align the holes in the switch

housing with the holes in the plate. Secure the switch

housing assembly by reinstalling the three screws

removed in the previous step.

CAUTION! Do not pinch wires between the switch

housing assembly and the plate.

ALLEN SET SCREW

⁄

-20 x

⁄

(PRE-INSTALLED)

Prepare for fan installation as follows:

Step 4. Route the wires from the motor through the canopy,

then the Perma • Lock™ downrod and ball assembly.

Tip: The downrod has a tapered thread

that is designed to lock completely when

correctly installed.

Step 5. Using the provided allen wrench, loosen the set screw

several turns to allow installation of the downrod. Thread

the downrod into the motor coupling until it stops turning,

this will take at least four and a half full turns.

Step 6. Securely tighten the set screw with the provided allen

wrench to ensure safe operation of your fan.

CAUTION: Failure to fully lock in the down-

rod before securely tightening the allen set

screw may cause the fan to separate from

the downrod during normal operation!

Installing a New Ceiling Fixture Outlet Box

If you do not have an existing fixture located where you wish

to place your fan, an approved ceiling fixture outlet box must

be installed and wired.

WARNING: To reduce the risk of fire, electrical shock,

or personal injury, mount to outlet box marked

acceptable for ceiling fan support using the

mounting hardware provided with the outlet box.

SWITCH HOUSING INSTALLATION

PERMA • LOCK™ HARDWARE

3mm

ALLEN WRENCH

FAN PREPARATION

GETTING STARTED

MOUNTING

SCREW

(3)

GROUND

WIRE

TAPERED

THREAD

ALLEN

SET SCREW

Using Existing Ceiling Fixture Outlet Box

After turning the power OFF at its source (either circuit breaker

or fuse box), lower the old fixture and disconnect the wiring.

Check the ceiling fixture outlet box to be sure that it is

marked 'Approved for ceiling fan mounting' . If it is not, a new

box must be installed.

NOTE: Please see chart on Page 8 for fan weights.

DOWNROD & BALL

ASSEMBLY

MOTOR

WIRES

BLUE

WIRE

CANOPY

DOWNROD

MOTOR

COUPLING