Gammill PLUS Manuel - Sayfa 11

Dikiş Makinesi Gammill PLUS için çevrimiçi göz atın veya pdf Manuel indirin. Gammill PLUS 12 sayfaları.

Each time a full bobbin is inserted in

the machine, the bobbin count

screen should be accessed and +

(plus) should be pressed to reset it

back to the full count. Failure to reset

bobbin count when full bobbin is

installed will result in false alarms.

Bobbin count screen can be

accessed at any time to check the

number of counts remaining even

though alerts have not been

activated. Run/Stop and Needle

Position switches will not operate

while bobbin count screen is open.

Touch – (minus) to exit screen and

return to normal operation.

Motor Run-Time Clock

To read the built-in Run-Time Clock,

press M on the display panel while

turning on the power. Hold M for

approximately two seconds to allow

for run time clock to boot up. The

hours and minutes shown represent

the total time the motor on this

machine has run.