MAJORCHARGE MajorCharge36/20 Kullanıcı El Kitabı - Sayfa 4
Akü Şarj Cihazı MAJORCHARGE MajorCharge36/20 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. MAJORCHARGE MajorCharge36/20 8 sayfaları. Gel, pro, hd series 6/8/12/16/24/36/48 volt
Sayfayı YazdırWORKING IN VICINITY OF A LEAD-ACID
1.
BATTERY IS DANGEROUS. BATTERIES
GENERATE EXPLOSIVE GASES DURING
NORMAL BATTERY OPERATION. FOR
THIS REASON, IT IS OF THE UTMOST
IMPORTANCE THAT EACH TIME BEFORE
USING YOUR CHARGER, YOU READ THIS
MANUAL AND FOLLOW THE
INSTRUCTIONS EXACTLY.
To reduce risk of battery explosion, follow
2.
these directions and those published by the
battery manufacturer and the manufacturer of
any equipment you intend to use in vicinity of
the battery. Review cautionary marking on
these products and on engine.
1. Someone should be within range of your voice or
close enough to come to your aid when you work
near a lead-acid battery.
2. Have plenty of fresh water and soap nearby in
case battery acid contacts skin, clothing or eyes.
3. Wear complete eye protection and clothing
protection. Avoid touching eyes while working
near battery.
4. If battery acid contacts skin or clothing, wash
immediately with soap and water. If acid enters
eyes, immediately flood eyes with running cold
water for at least 10 minutes and get medical
attention immediately.
5. NEVER smoke or allow a spark or flame in the
vicinity of battery or engine.
6. Be extra cautious to reduce risk of dropping a
metal tool onto battery. It might spark or short-
circuit battery or other electrical part that may
cause explosion.
7. Remove personal metal items such as rings,
bracelets, necklaces, and watches when working
with a lead-acid battery. A lead-acid battery can
produce a short circuit high enough to weld a ring
or the like to the metal, causing a severe burn.
8. Use charger for charging a LEAD-ACID
BATTERY ONLY. Do not use battery charger for
charging dry-cell batteries that are commonly
used with home appliances. These batteries may
burst and cause injury to persons and damage to
property.
9. NEVER charge a frozen battery.
MajorPower.Com
1. If necessary to remove battery from vehicle to
charge, always remove grounded terminal from
battery first. Make sure all accessories in vehicle
are off so as not to cause an arc.
2. Be sure area is well ventilated while battery is
being charged. A piece of cardboard or other
nonmetallic material can be used as a fan.
3. Clean all battery terminals. Be careful to keep
corrosion from coming in contact with eyes.
4. Add distilled water in each cell until battery acid
reaches level specified by battery manufacturer.
This helps purge excessive gas from cells. Do not
overfill. For a battery without cell caps, carefully
follow manufacturer's recharging instructions.
5. Study all battery manufacturer's precautions, such
as removing/not removing cell caps while charging
and recommended rates of charge.
6. Determine voltage of battery by referring to car or
equipment owner's manual and make sure it
matches output rating of battery charger.
1. Place charger as far away from battery as charging
cables will permit.
2. Never place charger above battery being charged;
gasses from battery will corrode and damage
charger.
3. Never allow battery acid to drip on charger.
4. Do no operate charger in a closed-in area or
restrict ventilation in any way.
5. Do not set a battery on top of a charger.
1. Connect and disconnect DC output only after
removing AC cord from electric outlet. Never allow
clips to touch each other.
2. Attach clips to battery posts and twist or rock back
and forth several times to make a good
connection, preventing clips from slipping off
terminals and reducing risk of sparking.
All 117 AC Volt PRO & HD chargers have an AC input
fuse located in the fuse drawer found below the AC
power cord. To access it, remove the power cord and
use a screwdriver to open the fuse compartment. If the
fuse requires replacement, the same type and value
fuse must be used. The rating for the fuse is found on
the SERIAL number label.
http://www.majorpower.com