2KRC P001 Montaj Kılavuzu - Sayfa 6
Oyuncak 2KRC P001 için çevrimiçi göz atın veya pdf Montaj Kılavuzu indirin. 2KRC P001 17 sayfaları. Hyper ep. fun scale racer
12
13
14
15
Cut Elev. Control hone as show.
install the " Z" push rod with control horn first then
check the control wire was operation smooth or not
when you install the wire and pre install Elevator
Control horn.
Before you ensure the control wire are operation
smooth, please do not glue the control horn in anyway.
If you find the "Z" end control wire angle not right,
please adjust it again or turn to other side to install the
"Z" end with the control horn.
After you ensure the Elevator Control wire was good
fit with Elevator Control horn and other end of control
wire was already fit in side the adjuster that already
install on the Elevator Servo,(see PIC. 16) you can
glue the control horn with thin CA. as show.
04