Gamry Reference 3000 Hızlı Başlangıç Kılavuzu - Sayfa 7

Analitik Cihazlar Gamry Reference 3000 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Gamry Reference 3000 16 sayfaları. Usb potentiostat installation
Ayrıca Gamry Reference 3000 için: Hızlı Başlangıç Kılavuzu (4 sayfalar)

Sayfayı Yazdır

988-00008

Reference 3000

Connect the Power Brick to an AC Power

Source

The AC to DC power brick included with your system requires

power from a 110V or 220V AC power outlet. The cable

included with the system is suitable for use with 110V style

power outlets. A converter or cable appropriate for 220V

power outlets is not included with the shipment, but any IEC

C13 line socket power cord can be used.

Connect the power cord to the power brick as shown, and

then plug the other end into an available AC outlet.

Connect the Power Cord to the Rear of the

Potentiostat

The instrument is powered by a DC power connector from the

power brick included with the system.

To power the instrument, connect the male end of the power

cable to the Power In female connector on the rear of the

instrument.

Attach Cell Cable to Potentiostat

Two cell cables is shipped with the potentiostat. One end of

the cable has multiple color-coded cell leads ending in

alligator clips. The other end of the cables have a fifteen pin

male or female D connectors.

To install the cell cable:

Turn on the Potentiostat

After both the USB cable and the DC power cable have been

attached to the rear of the potentiostat, turn on the instrument

using the power toggle switch on the rear panel.

The blue power LED on the front of the instrument should

flash 3 times, and then stay lit. The green USB LED should

also light and stay lit light while the computer is powered.

If either of these LEDs do not stay lit, double check your

connections as described. If you have made all of the

connections properly and are still unable to resolve the

problem, contact Gamry Instruments for assistance.

™

Potentiostat/Galvanostat/ZRA Quick-Start Guide

Connect the cell cables to the appropriate fifteen pin D

connector on the front of the Reference 3000.

Use the screws on the cable connector to secure the

connection. (Although screwdriver slots are provided,

connecting the cable screws finger-tight is sufficient.)