AGUZZO Dual Wired Ezy-Fit Kurulum Talimatları Kılavuzu - Sayfa 3
Kurutucu AGUZZO Dual Wired Ezy-Fit için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. AGUZZO Dual Wired Ezy-Fit 13 sayfaları. 304 stainless steel heated towel rail
Key Specifications
Construction: 304 Stainless Steel -- corrosion protection -- no chrome
Electrical: Tested and certified to comply with AS/NZ: 60335 and c-tick requirements
IP55 Rated: Water splash and spray proof
Power supply: 220-240 Vac. 50/60Hz
Approval: CE, EMC(C-Tick), LVD, RoHS, SAA(AS/NZ 60335), PSE(J60335-1), IP55
Important Safeguards
Note: This appliance is not intended for use by persons (including children) with reduced
physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety. Children should be supervised to ensure that they do not play with
the appliance.
§ Eliminate choking and suffocation hazards for young children by removing and safely
discarding all protective packaging and the protective cover on the power plug.
§ This appliance operates at a room temperature that is hot but not scalding to touch (up to
55°C). Rises in ambient temperature and the insulation effect of towels can cause the
operating temperature to rise. Young children and infirm persons should be supervised
near this appliance.
§ Do NOT use this towel rail to dry clothing or articles that have been in contact with oil,
petroleum based products, or dry cleaning fluids.
§ Use this appliance ONLY on the voltage specified on its electrical specification label.
§ Do NOT use this appliance other than for its intended use.
§ IPX5 rated to withstand water splashes and sprays. Do NOT immerse in liquid.
§ Do NOT allow the power supply cord to come into contact with any heated surfaces.
Installation Requirements
§ Carefully read all instructions before installation and operation
§ If you are hard-wiring or connecting to switch/controller. this appliance MUST be installed
by a qualified and licenced electrician in accordance with relevant wiring rules (AS/NZ
3000:2000 in Australia and New Zealand)
§ It MUST be installed so the bottom rail is at least 600mm from the floor
§ It MUST be installed at least 1.7 metres from combustible materials such as drapes and
furnishings
§ The appliance is supplied with an earthed 3-core supply cord and plug. This cord and plug
MUST be positioned so it is not subject to splashing water or ingress of moisture
§ Install with a suitable switch or controller:
- Plug into a power point with a switch
- Hardwire to a wall switch
- Hardwire to a compatible controller (such as a timer or thermostat switch)
§ Do NOT install or operate with a damaged cord or plug
§ Do NOT cover the cord and ensure it is arranged so it does not pose a risk
§ Do NOT install outdoors
Copyright 2018 Aguzzo
Aguzzo
is a brand member of the Vanguard Design Group
©
IMPORTANT: Retain this
instruction booklet for
future reference