IKEA FULLGORA Manuel - Sayfa 7

Buzdolabı IKEA FULLGORA için çevrimiçi göz atın veya pdf Manuel indirin. IKEA FULLGORA 40 sayfaları.
Ayrıca IKEA FULLGORA için: Manuel (44 sayfalar)

Sayfayı Yazdır

ENGLISH

cable - risk of fire or electric shock.

Only activate the appliance when the

installation has been completed.

Be careful not to damage the floors

(e.g. parquet) when moving the appliance.

Install the appliance on a floor or support

strong enough to take its weight and in a

place suitable for its size and use. Make

sure the appliance is not near a heat

source and that the four feet are stable

and resting on the floor, adjusting them

as required, and check that the appliance

is perfectly level using a spirit level. Wait

at least two hours before switching

the appliance on, to ensure that the

refrigerant circuit is fully efficient.

WARNING: When positioning the

appliance, ensure the supply cord is not

trapped or damaged.

WARNING: To avoid a hazard due to

instability, positioning or fixing of the

appliance must be done in accordance

with the manufacturer instructions. It's

forbidden to place the refrigerator in such

way that the metal hose of gas stove,

metal gas or water pipes, or electrical

wires are in contact with the refrigerator

back wall (condenser coil).

To guarantee adequate ventilation,

leave a space on both sides and above

the appliance. The distance between

the rear of the appliance and the wall

behind the appliance should be 50 mm, to

avoid access to hot surfaces. A reduction

of this space will increase the Energy

consumption of product.

ELECTRICAL WARNINGS

It must be possible to disconnect

the appliance from the power supply by

unplugging it if plug is accessible, or by

a multi-pole switch installed upstream of

the socket in accordance with the wiring

rules and the appliance must be earthed in

conformity with national electrical safety

standards.

Do not use extension leads, multiple

sockets or adapters. The electrical

components must not be accessible to

the user after installation. Do not use the

appliance when you are wet or barefoot.

Do not operate this appliance if it has

a damaged power cable or plug, if it is

not working properly, or if it has been

damaged or dropped.

If the supply cord is damaged, it must

be replaced with an identical one by the

manufacturer, its service agent or similarly

qualified persons in order to avoid a

hazard - risk of electric shock.

WARNING: Do not locate multiple

portable socket-outlets or portable power

supplies at the rear of the appliance.