IKEA GENOMKYLD Talimatlar Kılavuzu - Sayfa 16

Buzdolabı IKEA GENOMKYLD için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. IKEA GENOMKYLD 20 sayfaları. French door

Sayfayı Yazdır

CARE AND CLEANING

Warning! Refer to Safety chapters.

General warnings

Caution! Unplug the appliance before

carrying out any services.

This appliance contains hydrocarbons in its

cooling unit; maintenance and recharging

must therefore only be carried out by

authorized technicians.

The accessories and parts of the appliance

are not suitable for washing in a dishwasher.

Cleaning the interior

Before using the appliance for the first time,

the interior and all internal accessories

should be washed with lukewarm water and

some neutral soap to remove the typical

smell of a brand-new product, then dried

thoroughly.

Caution! Do not use detergents or abrasive

powders, as these will damage the finish.

Initial power on

Caution! Before inserting the power plug in

to the outlet and switching on the cabinet for

the first time, leave the appliance standing

upright for at least 4 hours. This will assure

a sufficient amount of time for the oil to

return to the compressor. Otherwise the

compressor or electronic components may

sustain damage.

Periodic cleaning

Caution! Do not pull, move or damage any

pipes and/or cables inside the cabinet.

Caution! Take care of not to damage the

cooling system.

Caution! When moving the cabinet, lift it by

the front edge to avoid scratching the floor.

The equipment has to be cleaned regularly:

1. Clean the inside and accessories with

lukewarm water and some neutral soap.

2. Regularly check the door seals and wipe

clean to ensure they are clean and free

from debris.

3. Rinse and dry thoroughly.

4. If accessible, clean the condenser

and thecompressor at the back of the

appliance with a brush. This operation

will improve the performance of

the appliance and save electricity

consumption.

This appliance contains hydrocarbons in its

cooling unit maintenance and recharging

must therefore only be carried out by

authorized technicians.