Gandy 12-Ft Operatör El Kitabı - Sayfa 3

Serpme Gandy 12-Ft için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Gandy 12-Ft 10 sayfaları. Drop spreader

Maintenance of 10T Series Spreaders:

Lubrication of Spreader:

There are a total of 9 grease fittings on this spreader that need to be greased twice –a-day.

These 9 grease fittings are greased from the factory but double check that none were missed.

There is 1 on the optional hand shut-off, if used to be greased periodically as needed.

Left & Right Wheel Hubs & Wheel Hub Collars: (Three on Left End & Three on Right End)

The wheel hubs have a built-in grease reservoir and should be greased generously twice daily.

The front and rear collars need to be greased twice daily.

When properly lubricated grease should come out the parting line between the front and rear collars.

One Grease Fitting on Left & Right Wheel Hub

One Grease Fitting on Front & Rear Collar

Left & Right End & Center Bearing: (Three Total)

These three bearings need to be greased sparingly twice daily. Do not over grease as this will force excess

grease out into the spreader compartment and can cause interference with followability of material.

Grease Fitting Left & Right End Bearing

Grease Fitting Center Bearing

Knee Lever:

(only if using the manual shut-off lever)

Grease the knee lever mounted to the hitch by

the cam gauge periodically as needed.

~ 1 ~