Decolav JORDAN MODULAR 1666 Manuel - Sayfa 5

İç Mekan Mobilyaları Decolav JORDAN MODULAR 1666 için çevrimiçi göz atın veya pdf Manuel indirin. Decolav JORDAN MODULAR 1666 11 sayfaları.

INSTALLING A DRAWER CONSOLE AND THE SUPPORT LEG TO THE VANITY

o Unpack the Drawer Console, Vanity and Support Leg.

o Remove the door and drawers from the Drawer console and the Vanity. (This will make installation a lot

easier)

o Look inside the Vanity, you will see 2 holes near the top of the Vanity. These holes are bored halfway

through from the factory. On the side that you wish to hook the drawer console or the Vanity Drawer to,

bore the holes all the way through using a .394" (10 mm) drill bit.

o Lay Vanity and Drawer Console on the fl oor, back down.

o Slide the Drawer Console next to the Vanity lining up the holes at the top.

o Using the connecting bolts and T-nuts attach the drawer console to the Vanity. The connecting

T-nuts go on the Drawer console side and the Connecting Bolts go on the Vanity side. Tighten connecting

bolts and insert three small wood screws into the holes in the T-nut. This will lock the T-nut in place. Figure

o There will be 3 unused holes at the bottom of the Drawer console (below bottom panel). These holes are

for connecting screws. Install the 3 screws through the drawer console and into the vanity using a

cordless screwdriver. Figure D

o Place the support leg next to the drawer console. Line up the the preinstalled insert nut holes

with the holes in the end panel of the drawer console. Figure C

o Using the connecting bolts attach the support leg to the Drawer console. Only 2 connecting bolts will be

used. At the bottom of the drawer console there are 3 screw holes (below the bottom panel) Install screws

into the support leg using a cordless screwdriver. Figure D

Factory

Installed

insert nut

(2 total)

Customer Service: 561-274-2110

www.decolav.com

JORDAN MODULAR SERIES

T-Nut (4 Total)

Small Wood Screw

(12 total)

There are 2 holes on each end panel of the vaity. The

holes are bored half way through the panel from the

factory. Customer will bore holes all the way through.

Bore all both hole through the panel when hooking up

the Drawer Console or the Vanity Drawer.

Connecting

Bolt (4 Total)

Flat Washer (4 Total)

LET YOUR DREAMS COME ALIVE, YOUR PASSIONS

BECOME REALITY, BE THE ENVY OF YOUR NEIGHBORS

Figure C