decon IN0120 Montaj Talimat Kılavuzu - Sayfa 7

Kamera Aksesuarları decon IN0120 için çevrimiçi göz atın veya pdf Montaj Talimat Kılavuzu indirin. decon IN0120 8 sayfaları. Simplex

Adjustments

The equipment will be ready for use when delivered, below adjustment should only be

performed if there is a special need or if the equipment has been moved to another chair. It

is possible to adjust the friction in the hinge and the locking force of the latch. However,

this should be done with caution. After adjusting, always verify that the click lock locks /

unlocks properly and that the hinge does not go too easily / sluggishly during the up /

down movement.

1. Screw for adjusting the friction in the hinge.

2. Cable tie for fixing the signal cable.

3. Screws for adjusting the locking force. Apply a small quantity Loctite 243 or

equivalent on these screws to avoid loosening. Adjust both sides equally.

4. Apply a small quantity of grease to the contact surfaces of the click-lock after

adjustment, wipe off excess.

2020-06-23

7(8)