IKEA BARMHARTIG Kurulum Talimatları Kılavuzu - Sayfa 13
Hob IKEA BARMHARTIG için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. IKEA BARMHARTIG 20 sayfaları.
Ayrıca IKEA BARMHARTIG için: Manuel (36 sayfalar)
Sayfayı Yazdır
ENGLISH
Problem
The residual heat indicator is
not displaying anything.
There is no signal when you
touch panel symbols.
symbol plus a number
appears on the power set-
ting display.
lights up on the power
setting display.
If there is an error, first try to find a solution
to the problem yourself. If you cannot find a
solution to the problem yourself, contact
your dealer or the After Sales Service.
Installation
Warning! Refer to Safety
chapters.
General information
Manufacturer is not responsible for any
injury to persons and pets or damage to
property caused by failure to comply
following requirements.
Possible cause
The cooking zone was only
on for a short time and is
therefore not hot.
The signals are deactivated. Activate the signals. Refer to
Electronic component error.
The second phase of the
power supply is missing.
Remedy
If the cooking zone is sup-
posed to be hot, call the Af-
ter Sales Service.
OffSound Control.
Disconnect the appliance
from the electrical supply for
a few minutes. Remove the
fuse, wait one minute, and
insert the fuse again.
Check if the hob is correctly
connected to the electrical
supply.
Remove the fuse, wait one
minute, and insert the fuse
again.
If you operated the appliance
wrongly, or the installation was
not carried out by a registered
engineer, the visit from the After
Sales Service technician or
dealer may not take place free
of charge, even during the
warranty period.
Caution! To proceed with the
installation refer to the assembly
instructions.
Warning! Installation process
must follow the laws, ordinances,
directives and standards
(electrical safety rules and
regulations, proper recycling in
accordance with the regulations,
etc.) in force in the country of use!
13