IKEA FORDELAKTIG Manuel - Sayfa 9

Hob IKEA FORDELAKTIG için çevrimiçi göz atın veya pdf Manuel indirin. IKEA FORDELAKTIG 32 sayfaları.
Ayrıca IKEA FORDELAKTIG için: Manuel (32 sayfalar)

Sayfayı Yazdır

ENGLISH

General information

General recommendations

• Never use scouring pads, steel wool, muriatic

acid or other products which could scratch or

mark the surface.

• For safety reasons, do not clean the appliance

with steam blasters or high-pressure cleaners.

• Foods that accidentally fall or settle on

the surface, on the functional or aesthetic

elements of the hob must not be eaten.

Cabinet requirements

• The cooking hob is intended to be built into

the worktop above a kitchen cabinet of 800

mm width or more.

• If fitting in flammable material, the guidelines

and standards for low voltage installations

and for the fire protection must be strictly

observed.

• For fitted units, the components (plastic

materials and veneered wood) must be

assembled with heat-resistant adhesives (min.

85°C): Unsuitable materials and adhesives can

result in warping and detachment.

• The kitchen cabinet must allow sufficient

room for the electrical connections of the

appliance. Suspended kitchen cabinets above

the appliance must be installed at a distance

that provides enough room for comfortable

working process.

• The use of hard wood decorative borders

around the worktop behind the appliance is

allowed, in this case the minimum distance

remains as indicated on the installation

illustrations.

• Positioning and dimensions of the cut-out for

built-in appliance is shown in the illustration

below. The measurements shown are

only valid if the following condition is met:

worktop overhang to cabinet front is 35mm.

• Minimum distance between built-in appliance

and any cabinet above it is 500mm.

773

490

555 mm

18 - 40mm

• To prevent leakage of liquid between the

edge of the hob and the countertop, place

the adhesive seal provided along the entire

outer edge of the hob before assembly.

Please refer to Assembly Instruction.

Use

• The extractor appliance has been designed

exclusively for domestic use to eliminate

kitchen smells.

• Never use the appliance for purposes other

than for which it has been designed.

• Deep fat fryers must be continuously

monitored during use: overheated oil can

burst.

• Do not operate the appliance with an

external time switch or a separate remote

control system.

• The appliance shall not be installed behind a

decorative door in order to avoid overheating.

• To avoid damaging the appliance, do not

climb onto the appliance.

• To avoid damaging the silicon grouting, do

not put hot cookware on the frame.

• Do not cut or prepare food on the surface

or drop hard objects onto it. Do not drag

cookware across the surface.

Min. 500 mm