Century Helicopter Products Schweizer 300 Scale Kullanım Kılavuzu - Sayfa 3
Oyuncak Century Helicopter Products Schweizer 300 Scale için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Century Helicopter Products Schweizer 300 Scale 12 sayfaları.
Sayfayı Yazdır
Schweizer 300 Construction Manual
This manual has been written to cover assembly of the Schweizer 300 Conversion kit CN1033 and isthe
supplemental instructions for the full kit CN1030 to work in conjunction with the Hawk III instruction
manual. Through following the instructions, modifications can be made to the mounting for other
helicopters in the 30-46 class. This instruction set is a supplement to the Hawk helicopter instruction
manual, changes are listed below to the major areas that are different than the original kit.
Every attempt has been made to ease the assembly of your Schweizer 300. At each step where there is a
complex assembly, detailed written instructions are provided to walk you through the building process.
Take a few minutes before each step to review the instructions, examine the hardware utilized in that
step, and compare the drawings & pictures to your work in progress.
Schweizer 300 Body Kit
Schweizer 300 Hawk Conversion Kit
Symbols used to help assist you in building the kit:
Apply
"Goop"
Special
Attention
Hardware Description and Identification:
M3x6 Self Tapping Screw
The tools and materials listed below are the
minimum needed to build the Schweizer 300.
Screwdrivers - Slotted and Phillips head.
Hex Key 2.5mm
Long-Nosed Pliers.
Paper Clip
Scissors & Ruler
Locktite (thread lock liquid)
Clear cellophane or masking tape.
Drill and drill bits (1/16", 1/8")
Repeat Steps
as specified
Apply
threadlock
M3x6 = 3x6mm and can refer to screws or fasteners.
M3x10 Socket Cap Screw
M - metric
3 - diameter
6 - length
Complete Steps 1 through 10
Complete Steps 11 - 18
Partially
tighten
Purchased
Separately
M - metric
3 - diameter
6 - length
Recommended Tools & Accessories
In addition, the following will make
assembly and setup easier, and prove
useful later in your model toolbox:
Primer and paint to match box art.
5.0mm Open End Wrench.
5.5mm Open End Wrench.
7mm Open End Wrench.
Helpful
Tip
Cut away
Shaded
Portion
2