Airflow Silent+ Mini Orange Kullanım Kılavuzu - Sayfa 13

Ölçüm Cihazları Airflow Silent+ Mini Orange için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Airflow Silent+ Mini Orange 14 sayfaları.

Fault: Pump runs all the time.

1. Is the float position with the magnet uppermost?

2. Is the reservoir lid (sensor) located firmly onto the reservoir, with the

float located inside the reservoir, around the sensor column?

3. Is there sludge inside the reservoir, preventing float from resting on

the bottom? (This may occur if the pump has been in operation for

some without cleaning. Clean using an anti-bacterial wash.)

Please note:

• After installation and during operation, if you notice air

in the pipe between the reservoir and the pump, you

have a siphoning problem (Fit an Anti Siphoning Device

following step 10 on page 10).

• The pump will only switch off when the float is at the

bottom of the reservoir.

Fault: Pump stops and starts and makes a loud noise.

1. The water is siphoning through the pump. Fit an Anti Siphoning

Device following step 10 on page 10.

Fault: Pump runs but does not pump any water.

1. Are there any air leaks in the pipe running to the pump?

2. Check that reservoir, filter and inlet tube are free of sludge and

debris.

Fault: Pump isn't operating at all.

1. Is power reaching the pump? Is it correctly wired? Is the

voltage correct?

2. Is the pump very hot? A thermal cut0out may have been

activated to protect pump.

This will automatically reset once pump has cooled down.

Have you got another question?

Phone: +44 (0) 1494 525252