IKEA Livsgnista Kullanım Kılavuzu - Sayfa 8

Hob IKEA Livsgnista için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. IKEA Livsgnista 37 sayfaları. Ikea livsgnista hob instruction manual

Sayfayı Yazdır

ENGLISH

Helpful hints and tips

This hob has burners of different diameters.

For better burner performance, please stick

to the following rules:

Use pots and pans with bottoms the

same width as that of the burners or

slightly larger (see table on the right).

Only use flat-bottomed pots and pans.

Use the correct amount of water

for cooking foods and keep the pot

covered.

Make sure pots on the grates do not

Burner

Rapid

Semi-rapid

Auxiliary

Maintenance and cleaning

Disconnect power before servicing.

All the enamelled and glass parts

should be cleaned with warm water and

neutral solution.

Stainless steel surfaces may be stained

by calcareous water or aggressive

detergents if left in contact for too long.

Any food spills (water, sauce, coffee, etc.)

should be wiped away before they dry.

Clean with warm water and neutral

detergent, and then dry with a soft

cloth or chamois. Remove baked-on dirt

with specific cleaners for stainless steel

surfaces.

NOTE: Clean glass and enamelled parts

only with soft cloth or sponge.

Do not use abrasive or corrosive

products, chlorine-based cleaners or

pan scourers.

Do not use steam cleaning appliances.

Do not use flammable products.

protrude beyond the edge of the hob.

IMPORTANT: improper use of the grids can

result in damage to the hob: do not position

the grids upside down or slide them across

the hob. Do not use:

Cast iron griddles, ollar stones,

terracotta pots and pans.

Heat diffusers such as metal mesh, or

any other types.

Two burners simultaneously for one

receptacle (e.g. fish kettle).

Pot Ø

from 24 to 26 cm

from 16 to 22 cm

from 8 to 14 cm

Do not leave acid or alkaline substances,

such as vinegar, mustard, salt, sugar or

lemon juice on the hob.

CLEANING THE HOB PARTS

Grids, burner caps and burners can be

removed to be cleaned. Do not wash

them in the dishwasher.

Clean them by hand with warm water

and non-abrasive detergent, removing

any food residues and checking that

none of the burner openings is clogged.

Rinse and dry

Refit burners and burner caps correctly

in the respective housings.

When replacing the grids, make sure

that the panstand area is aligned with

the burner.

Models equipped with electrical

ignition plugs and safety device require

thorough cleaning of the plug end in

order to ensure correct operation.