IKEA OTROLIG Manuel - Sayfa 14
Hob IKEA OTROLIG için çevrimiçi göz atın veya pdf Manuel indirin. IKEA OTROLIG 20 sayfaları.
Ayrıca IKEA OTROLIG için: Manuel (16 sayfalar), Montaj Kılavuzu (16 sayfalar), Montaj Kılavuzu (16 sayfalar)
Sayfayı Yazdır
ENGLISH
Installation and electrical connection
WARNING. Disconnect the appliance
from the mains power supply.
- The appliance must be installed by a
qualified technician who is fully aware of
current safety and installation regulations.
- The manufacturer declines all liability
for injury to persons or animals and for
damage to property resulting from failure
to observe the regulations provided in this
chapter.
- The power supply cable must be long
enough to allow the hob to be removed
from the worktop.
- Make sure the voltage specified on the
appliance rating plate is the same as that of
the domestic power supply voltage.
- Do not use extension cables.
Connecting to the terminal board
For electrical connection, use an H05RR-F
cable as specified in the table below.
Conductors
220-240 V ~ +
220-240 V 3 ~ +
380-415 V 3N ~ +
380-415 V 2N ~ +
Important:
- Keep or remove the metallic bridges
between the the screws L1-L2 and N1-N2 of
the terminal block accordingly to the wiring
diagram (see figure)
- Make sure to fasten all the six screws of
the terminal block after the cable connection
Amount x size
3 x 4 mm
2
4 X 1.5 mm
2
5 X 1.5 mm
2
4 X 1.5 mm
2
A
Example of bridge present (left) or absent
(right) between N1 and N2 (check L1-L2
and N1-N2 bridges in the wiring diagram)
Connect the yellow/green earth wire to the
terminal with the symbol
This wire must be longer than the other
wires.
1. Remove the terminal block cover (A),
undoing the screw and inserting the
cover in the terminal block hinge (B).
2. Insert the power supply cable into the
cable clamp and connect the wires to
the terminal board as indicated in the
diagram next to the terminal board
itself.
3. Secure the power cable with the cable
clamp.
4. Close the cover (C) and screw it on the
terminal block with the removed screw -
point (1).
A
A
B
Each time the cooktop is connected to the
mains it carries out an automatic check
which lasts several seconds.
Connect the appliance to the electricity
supply by means of an all-pole disconnect
switch with minimum contact gap of 3 mm.
14
.
C