CeoTronics CT-DECT Base Kullanım Talimatları Kılavuzu - Sayfa 9

Kulaklıklar CeoTronics CT-DECT Base için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. CeoTronics CT-DECT Base 14 sayfaları. Headset for wireless duplex communication
Ayrıca CeoTronics CT-DECT Base için: Kullanım Talimatları Kılavuzu (20 sayfalar), Kullanım Talimatları Kılavuzu (20 sayfalar), Kullanım Talimatları Kılavuzu (14 sayfalar), Kullanım Talimatları Kılavuzu (20 sayfalar)

Sayfayı Yazdır

Commissioning and operation

4.1

Connecting the headset or hand microphone

a. Connect he communication set to the jack (Fig. 1/a) on the upper side of the unit.

b. If a communication headset is used – Put on the headset and adjust it so that it fits comfortably and

correctly.

If the hand microphone SM 3 is used – Fasten the hand microphone, if desired, with the clip on the

rear to a suitable place on your clothing.

c. Place the unit on a suitable place of your clothing.

NOTE

Protect the unit against dampness.

4.2

Switching on, synchronization, adjusting the speaker volume

a. Switch on the units by means of the on/off switch and volume control (rotary knob Fig. 1/b).

Synchronization: A high beep tone is audible in the communication set connected to the base unit

and to the standard unit approx. 10 seconds after switching on. The synchronization procedure then

begins, i.e. the base unit seeks its standard unit. This synchronization procedure can last approx. 30

seconds.

Upon completion of synchronization – i.e. the base unit has found its standard unit – a high double-

beep tone sounds in the communication set of the standard unit and of the base unit. Subsequently

the connection setup between the units is effected automatically and the units are ready for duplex

communication. In the case of two standard units two high double-beep tones are audible in the

communication set of the base unit upon successful completion of synchronization.

b. On voice reception adjust the speaker volume for your communication set by means of the on/off

switch and volume control knob (rotary knob).

NOTE

Always leave the units switched on as long as you work with the communcation system so that

immediate availability of the system is provided.

c. Connection setup and release see sections 4.3...4.3.3.

4.3

Connection setup and release and duplex communication

4.3.1 Automatic connection setup after switching on

After the base unit and the standard unit(s) are switched on the first connection setup between the units

is effected automatically (see section 4.2). Subsequently duplex communication (speech and

simultaneous listening) is possible via the communication sets connected to the units.

In the case of communication sets with PTT button, press the PTT button and keep it pressed while

speaking (see section 2.10).

4.3.2 Connection setup and release by the base unit

(1)

Prerequisites

Units subscribed (see sections 3...3.2.2)

Units switched on and synchronized (see section 4.2)

(2)

Two-party conference

Connection setup

Press one of the three the push-buttons in the middle of the push-button bank on the base unit. When

the connection is set up a high beep tone sounds in the communication set of the calling base unit and

of the called standard unit. Subsequently duplex communication (speech and simultaneous listening) is

possible for both parties. In the case of communication sets with PTT button, press the PTT button and

keep it pressed while speaking (see section 2.10).