Decor Connections FP551500SA Kullanıcı Kılavuzu - Sayfa 8

Kapalı Şömine Decor Connections FP551500SA için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Decor Connections FP551500SA 8 sayfaları. Firebox insert

Sayfayı Yazdır
Problem
Heater is on but no flame or low
flame intensity.
Flames are frozen.
Excessive
noise
in
portion of the heater.
"HEATER POWER" switch has been
flipped in the on position. but there
is no airflow.
Cause
Flame adjusting knob is at low
setting.
Loose wiring at the wall power
outlet.
Loose wiring at the wall power
outlet.
Flame element is not attached to
the motor.
Rotation motor is defective.
Flame
the
lower
properly.
Motor is defective.
The
air
completely blocked.
The heater system is over heated,
Temperature Limit Thermostat is
cut off.
Fan Motor is defective.
Fan blower is balanced badly.
element
isn't
seated
inlet
or
air
outlet
Solution
Turn the knob to maximum setting.
Contact a qualified electrician.
Check
all
wiring
connections. Contact a qualified
electrician.
Contact a qualified electrician.
Contact a qualified electrician.
Contact a qualified electrician.
Contact a qualified electrician.
Move the unit, make sure to leave
is
adequate space around the unit.
remove the blockage, on or in front
of the air outlet.
Check the air inlet and outlet. Turn
off the power switch and unplug it.
Wait ten minutes, then plug it back
in and turn the heater on again.
Contact a qualified electrician.
Contact a qualified electrician.
for
loose