IKEA IHW53UC0FS0 Kurulum Talimatları Kılavuzu - Sayfa 9
Havalandırma Davlumbazı IKEA IHW53UC0FS0 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. IKEA IHW53UC0FS0 30 sayfaları. 30" (76.2 cm) wall-mount canopy range hood
Sayfayı Yazdır
Install Range Hood
NOTE: Remove protective film from range hood and metal filters.
1. Using 2 or more people, hang range hood on 2 mounting
screws through the mounting slots on back of hood.
A
A. Mounting screws
B. Mounting slots
C. Lower mounting screws
2. Remove the grease filter. See "Range Hood Care" section.
3. Level the range hood and tighten upper mounting screws.
4. Install (2) 5 x 45 mm lower mounting screws and tighten.
Use the optional wall anchors if needed.
Connect Vent System
1. Install transition on top of hood (if removed for shipping)
with (2) 3.5 x 9.5 mm (Phillips) sheet metal screws.
A
B
A. Vent transition
B. 3.5 x 9.5 mm screw
For vented installations only:
1. Fit vent system over transition piece.
2. Seal connection with clamps.
3. Check that back draft dampers work properly.
For non-vented (recirculating) installation only:
1. Assemble the air deflector with the duct cover bracket with
B
2. Measure from the bottom of the air deflector to the bottom
C
3. Cut the duct to the measured size "X."
4. Remove the air deflector.
5. Slide the duct onto the bottom of the air deflector.
6. Place the assembled air deflector and duct over
7. Reassemble the air deflector to the duct cover bracket
8. Seal connections with vent clamps.
2 assembly screws.
B
A. Vent cover bracket
B. 2.9 x 6.5 mm screws
C. Deflector
of the hood outlet.
B
D
E
A. Air deflector
B. Vent clamp
C. X = length to cut vent duct
D. Vent duct
E. Exhaust outlet
the exhaust outlet from the hood.
with the 2 assembly screws.
A
B
C
A
C
X
9