IKEA IHW6362WM0 Kurulum Talimatları ve Kullanım & Bakım Kılavuzu - Sayfa 10
Havalandırma Davlumbazı IKEA IHW6362WM0 için çevrimiçi göz atın veya pdf Kurulum Talimatları ve Kullanım & Bakım Kılavuzu indirin. IKEA IHW6362WM0 28 sayfaları. 30" (76 cm), 35 7/16" (90 cm) wall-mount canopy range hood
Sayfayı Yazdır
Operating the Light
1. Move the light switch to the "1" position to turn on the light.
2. Move the light switch to the "0" position to turn off the light.
Operating the Blower and Adjusting Blower Speed
1. Move the blower switch to the "1" position for low speed, the
"2" position for medium speed or the "3" position for high
speed.
2. Move the blower switch to the "0" position to turn off the
blower.
RANGE HOOD CARE
5. Install charcoal filter over grille on blower housing and turn
filter handle clockwise.
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating hood.
Be sure lights are cool before cleaning the hood.
Exterior Surfaces
Clean the range hood with a mild detergent and soft cloth. To
avoid damage to the exterior surface, do not use abrasive
cleanser or steel-wool pads.
Metal Grease Filters
The filters should be washed frequently. Place metal filters in
dishwasher or hot detergent solution to clean.
Drain water through edge holes and let each filter dry thoroughly
before replacing it.
To Remove
Metal Grease Filters
1. Turn off fan and lights. Check that halogen lamp is cool.
2. Push handle toward the rear and pull downward.
3. Pull filter toward the front.
A. Blower housing
B. Filter handle
C. Charcoal filters
6. Repeat to install other charcoal filter.
7. Replace metal grease filters. See "Metal Grease Filters"
section.
To Replace Charcoal
Filters
1. Turn fan and lights off. Check that halogen lamp is cool.
2. Remove the metal grease filters. See "Metal Grease Filters"
section.
3. Turn charcoal filter counterclockwise.
4. Remove and discard both charcoal filters.
5. Install replacement charcoal filters over grille in blower
housing and turn filter handle clockwise.
6. Replace metal grease filters. See "Metal Grease Filters"
section.
To Replace
Metal Grease Filters
1. Insert back edge of filter into rear channel of the filter
opening.
2. Push handle toward the rear and push filter up.
3. Pull filter toward the front and insert into front channel.
Charcoal
Filters - For Non-Vented
(recirculating)
Installations
The charcoal filters are not washable nor reusable.
They should be changed every 6 months in normal use.
The charcoal filters capture unpleasant cooking odors.
To Install Charcoal
Filters
1. Turn fan and lights off. Check that halogen lamp is cool.
2. Remove the metal grease filters. See "Metal Grease Filters"
section.
3. Set metal grease filter aside.
4. Repeat to remove other metal grease filter.
Replacing
a Halogen
Lamp
Turn off the range hood and allow the halogen lamp to cool. To
avoid damage or decreasing the life of the new bulb, do not
touch bulb with bare fingers. Replace bulb, using tissue or
wearing cotton gloves to handle bulb.
If new lights do not operate, make sure the lamps are inserted
correctly before calling service.
1. Disconnect
power.
2. Use a flat-blade screwdriver and gently pry the light cover
loose.
3. Remove the lamp and replace with a 12-volt, 20-watt
maximum, halogen lamp made for a G-4 base.
4. Replace the light cover.
10