IKEA KULINARISK Manuel - Sayfa 32

Havalandırma Davlumbazı IKEA KULINARISK için çevrimiçi göz atın veya pdf Manuel indirin. IKEA KULINARISK 44 sayfaları. Oven with steam feature
Ayrıca IKEA KULINARISK için: Kullanım Kılavuzu (20 sayfalar), Kullanıcı Kılavuzu (36 sayfalar), Kullanıcı Kılavuzu (16 sayfalar), Kullanıcı Kılavuzu (36 sayfalar), Kullanıcı Kılavuzu (32 sayfalar), Manuel (36 sayfalar), Kullanım Kılavuzu (48 sayfalar), Talimatlar Kılavuzu (36 sayfalar), Manuel (24 sayfalar), Kurulum Talimatları Kılavuzu (36 sayfalar), Manuel (20 sayfalar), Kullanıcı Kılavuzu (36 sayfalar), Manuel (40 sayfalar), Manuel (40 sayfalar), Kullanıcı Kılavuzu (20 sayfalar), Manuel (37 sayfalar), Manuel (32 sayfalar), Hızlı Başlangıç Kılavuzu (16 sayfalar), Manuel (20 sayfalar), Manuel (20 sayfalar), Manuel (36 sayfalar), Manuel (21 sayfalar), Hızlı Başlangıç Kılavuzu (8 sayfalar), Manuel (40 sayfalar), Manuel (20 sayfalar), Manuel (32 sayfalar), Manuel (36 sayfalar), Manuel (17 sayfalar)

ENGLISH

4. Lift and turn the lever fully on the left

hinge.

5. Close the oven door halfway to the first

opening position. Then lift and pull

forward and remove the door from its

seat.

6. Put the door on a soft cloth on a stable

surface.

7. Hold the door trim (B) on the top edge

of the door at the two sides and push

inwards to release the clip seal.

8. Pull the door trim to the front to remove

it.

9. Hold the door glass panels by their top

edge and carefully pull them out one by

one. Start from the top panel. Make sure

the glass slides out of the supports

completely.

10. Clean the glass panels with water and

soap. Dry the glass panels carefully. Do

not clean the glass panels in the

dishwasher.

When the cleaning is completed, install the

glass panels, the door trim and the oven

door, close the levers on the both hinges.

Make sure that you put the glass panels (A,

B and C) back in the correct sequence.

Check for the symbol / printing on the side

of the glass panel, each of the glass panels

looks different to make the disassembly and

assembly easier.

The screen-printing zone must face the

inner side of the door. Make sure that after

the installation the surface of the glass

panel frame on the screen-printing zones is

not rough when you touch it.

When installed correctly the door trim clicks.