KitchenAid KICU540BSS0 Kurulum Talimatları Kılavuzu - Sayfa 3

Setüstü Ocak KitchenAid KICU540BSS0 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. KitchenAid KICU540BSS0 12 sayfaları. Electric induction cooktop

Sayfayı Yazdır

Cabinet

Dimensions

IMPORTANT: If you are installing a range hood or microwave

hood combination

above the range, follow the range hood or

microwave hood combination

installation instructions

for

dimensional clearances above the cooktop surface.

NOTES: After you make the countertop

cutout, some

installations may require notching down the base cabinet side

walls to clear the cooktop base. To avoid this modification,

use a

base cabinet with sidewalls wider than the cutout.

If the cabinet has a drawer, a 51/8 '' (13 cm) depth clearance from

the countertop to the top of the drawer (or other obstruction)

the base cabinet is required.

Electrical Shock Hazard

Disconnect power before servicing.

Use 8 gauge copper wire.

Electrically ground cooktop.

Failure to follow these instructions can result in death,

fire, or electrical shock.

A. 23½" (60.0 cm)

B. Combustible

area above countertop

(shown by dashed box above)

C. 30" (76.2 cm) minimum clearance between top of cooktop platform

and bottom of uncovered wood or metal cabinet (24" [61.0 cm]

minimum clearance if bottom of wood or metal cabinet is covered by

not less than ¼" [0.6 cm] flame retardant millboard

covered with not

less than No. 28 MSG sheet steel, 0.015" [0.04 cm] stainless steel, or

0.024" [0.06 cm] aluminum or 0.020" [0.05 cm] copper)

D. 13" (33.0 cm) recommended

upper cabinet depth

E. 2" (5.1cm)

F. 19" (49.0 cm)

G. 18" (45. 7 cm) minimum clearance from upper cabinet to countertop

within minimum

horizontal clearances to cooktop

H. Junction box or outlet; 12" (30.5 cm) minimum from bottom of

countertop

I. Junction box or outlet; 10" (25.4 cm) from right-hand

side of cabinet

J. 22" (56.0 cm)

K. 4" (10.0 cm) minimum distance to nearest left and right side

combustible

surface above cooktop

L. 2" (5.1 cm) minimum

clearance between back wall and countertop

M. IMPORTANT:

For proper ventilation, provide a vent of _"

(5 mm)

under the countertop,

in the front of the cabinet. The ventilation

opening is to extend the furl length of the cooktop cutout. See the

following

illustration.

If codes permit and a separate ground wire is used, it is

recommended

that a qualified electrical installer determine that

the ground path and wire gauge are in accordance

with local

codes.

Check with a qualified electrical installer if you are not sure the

cooktop is properly grounded.

It is not recommended

to have a fuse in the neutral or ground

circuit.

Make sure that the electrical connection and wire size are

adequate and in conformance

with the CSA Standards C22.1-94,

Canadian Electrical Code, Part 1 and C22.2 No. O-M91-1atest

edition, and all local codes and ordinances.

A copy of the above code standards can be obtained from:

CSA International

178 Rexdale Boulevard

Toronto, Ontario

Canada M9W 1R3

Before You Make the Electrical

Connection:

To properly install your cooktop, you must determine the type of

electrical connection you will be using and follow the instructions

provided for it here.

•

A 4-wire or 3-wire, single phase, 240 volt, 60 Hz., AC only

electrical supply is required on a separate circuit, fused on

both sides of the line.

•

The cooktop should be connected directly to the junction box

through flexible, armored or nonmetallic sheathed, copper

cable. The flexible, armored cable extending from the fuse

box or circuit breaker box should be connected directly to the

junction box.