KitchenAid KICU569XSS Kurulum Kılavuzu - Sayfa 2
Setüstü Ocak KitchenAid KICU569XSS için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. KitchenAid KICU569XSS 16 sayfaları. 30" (76.2 cm) and 36" (91.4 cm) electric
Ayrıca KitchenAid KICU569XSS için: Ürün Boyutları (1 sayfalar), Boyut Kılavuzu (8 sayfalar), Kurulum Talimatları Kılavuzu (16 sayfalar)
Sayfayı Yazdır
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Tape measure
Flat-blade screwdriver
Phillips head screwdriver
Hand or electric drill
Level
Parts supplied
Brackets (2)
2 " (6.4 cm) clamping screws (4)
#8 x
" (9.5 mm) sheet metal screws (4)
Parts needed
A UL listed or CSA approved strain relief
UL listed wire connectors
A UL approved junction box or 240V outlet
Cooktop Bracket Adhesive Kit Part Number W10310006 if
installing the cooktop into a marble countertop. See the
"Assistance or Service" section of the Use and Care Guide
for information on ordering.
Check local codes. Check existing electrical supply. See
"Electrical Requirements."
It is recommended that all electrical connections be made by a
licensed, qualified electrical installer.
Location Requirements
Make sure you have everything needed for correct installation. It
is the responsibility of the installer to comply with the installation
clearances specified in these instructions.
IMPORTANT: Observe all governing codes and ordinances.
When installing cooktop, use minimum dimensions given.
To eliminate the risk of burns or fire by reaching over the
heated surface units, cabinet storage space located above
the surface units should be avoided. If cabinet storage is to
be provided, the risk can be reduced by installing a range
hood that projects horizontally a minimum of 5" (12.7 cm)
beyond the bottom of the cabinets.
It is the installer's responsibility to comply with installation
clearances specified on the model/serial rating plate. The
model/serial rating plate is located on the underside of the
cooktop burner box.
2
INSTALLATION REQUIREMENTS
Marker or pencil
Pliers
¼" drill bit
Jigsaw
30" (76.2 cm) cooktop model/serial rating plate location
(models JIC4430 and KICU509)
A
A. Model/serial rating plate location
36" (91.4 cm) cooktop model/serial rating plate location
(models JIC4536 and KICU569)
A
A. Model/serial rating plate location
Check the cooktop base for an approved installation label.
Verify approved oven model numbers that can be installed
with your cooktop model number. If you do not find this label,
your cooktop may not be approved for use over an
undercounter built-in oven. Contact your dealer to confirm
that your cooktop is approved.
Ovens approved for this type of installation will have an
approval label located on the top of the oven. If you do not
find this label, contact your dealer to confirm that your oven is
approved. Refer to oven manufacturer's Installation
Instructions for approval for built-in undercounter use and
proper cutout dimensions.
When installing cooktop over an undercounter built-in oven,
do not fasten cooktop to countertop with clamps or seal
cooktop to countertop. This will make the cooktop easier to
remove if future servicing becomes necessary.
Use the countertop opening dimensions that are given with
these Installation Instructions. Given dimensions are
minimum clearances and provide 0" (0 cm) clearance.
Grounded electrical supply is required. See "Electrical
Requirements" section.