Avantco 178AU27FHC Kullanıcı Kılavuzu - Sayfa 6

Buzdolabı Avantco 178AU27FHC için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Avantco 178AU27FHC 10 sayfaları. Commercial refrigerators and freezers
Ayrıca Avantco 178AU27FHC için: Kullanıcı Kılavuzu (9 sayfalar)

Sayfayı Yazdır

User Manual

Adjusting the temperature changes the minimum temperature your unit will run at. Your unit will not

run constantly at this setting. To change it, follow these instructions:

Digital Control Units

• Hold "SET" for 1 sec. The display will flash the current minimum temperature.

• Use the arrow buttons to adjust the minimum temperature you want it to run at.

• Press "SET" again to save your settings.

Always remember to calculate the differential if you change the minimum temperature setting.

The cabinet temperature will fluctuate up to +7 degrees over your set minimum temperature as

the compressor runs and shuts off. Setting the temperature too high will result in unsafe maximum

temperatures.

Freezer Control (phased out in 2022)

Refrigerator and Freezer Control (2022 onwards)

Prg

aux

mute

set

Set

def

Loading Product

Before loading shelves, please be sure that all shelf clips are completely fastened in their correct

locations. It is important that all shelves rest completely level before stocking your cabinet with

product. In order to maintain correct air flow inside the unit, please be sure to leave 2-4" of space

between the back wall and stored product. Blocking the evaporator fans will result in a warmer

cabinet temperature and ultimately compressor failure.

Running a Manual Defrost Cycle

This unit is pre-programmed to run automatic defrost cycles at preset intervals. However, if you

would like to run a manual defrost cycle at any time, please follow the steps below:

Freezers produced before 2022: Press the defrost button ("def" and down arrow) for approximately

5 seconds. Repeat to stop the defrost cycle.

Refrigerators and Freezers: Press the defrost button (snowflake symbol and down arrow) for

approximately 3 seconds. Repeat to stop the defrost cycle.