Cequent 76112 Kurulum Talimatları Kılavuzu - Sayfa 5
Otomobil Aksesuarları Cequent 76112 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Cequent 76112 18 sayfaları. 2011-current toyota sienna
Sayfayı Yazdır
5. Open rear hatch: Open rear hatch on vehicle and remove 2 plastic rivet (1
each side) and 2 small bolt (1 each side).
7. Remove lower rear fascia: Gently pull up from the rear wheel well panel each side, unclipping the
tabs inside , while working around to rear. If present disconnect any wiring harness at the fascia, and
put the fascia cover aside. Carefully set the bumper aside.
©2016 Cequent™ Performance Products, Inc. -
Printed in Mexico
6. Remove screw from wheel well: Remove (1) Philip screw each side, located
inside fascia at the lower attaching points between rear fascia and rear side
panel of vehicle.
8. Raise hitch: Raise hitch into position and install hex bolts,
lock washers and flat washers into existing weldnuts in frame,
as shown above. Push hitch toward driver's side and tighten
fasteners.
Sheet 5 of 18
76112NP
11-10-16
Rev. B