KitchenAid 9741159 Kurulum Talimatları Kılavuzu - Sayfa 6

Bulaşık Makinesi KitchenAid 9741159 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. KitchenAid 9741159 8 sayfaları. Undercounter dishwasher

Sayfayı Yazdır
n-l
back of dishwasher
m
alternate
position
rear Gross channel
original
position
Check to see if rear cross
channel contacts drain,
electrical or water lines. If the channel
contacts any line, pull dishwasher
out
of opening. Do Not remove the
channel.
Remove both cross channel
screws on the right-hand side.
Remove the bottom screw on the left-
hand side and loosen the top screw.
Align the bottom hole in the loose end
of channel with the higher hole in
frame and attach with screw. Tighten
the top screw on the other end of
channel. Repeat Step 9.
Align dishwasher
door with
cabinet front, not doors.
compression
elbow (3/8" N PT one
end). Connect street elbow to water
valve. Connect supply line to
compression
elbow. If galvanized
pipe is used, use a second 3/8"
street elbow in place of the
compression
elbow.
Page 6
/
dishwasher
valve 9
d
h
at drain hose is not
kinked, crimped
or contactins
electrical
coi-mections.
-
Place towel below
dishwasher valve area.
Remove red plug from dishwasher
valve. (A small amount of water may
still be in the valve area from quality
assurance testing.) Place hose
clamp over dishwasher valve.
Connect drain hose to valve and
secure with hose clamp. Check for
good fit and that there are no bends
or kinks in drain hose that could
restrict water flow.
top mounting
,
brackets,
Do Not
drop
screws
into tub.
Open dishwasher and
remove foam shipping
pieces from upper corners of boor.
Remove bottom rack. Place a
newspaper or large sheet of paper
over bottom of dishwasher to protect
the pump area when securing
dishwasher to countertop.
Disconnect brackets
located at the top
corners of flange. Reattach brackets
with bracket end facing away from
dishwasher.
Drill starter holes 3/4"
deep through bracket holes into the
underside of countertop using a l/8"
drill bit. Do Not exceed 3/4" depth.
Attach brackets to underside of
countertop.
Make sure the screw
heads do not interfere with door.
You MUST secure dishwasher
to
keep it from tilting when door is
opened or closed. Do Not drop
screws in dishwasher
tub.
If
screws should
fall into pump,
pump and motor failure
may
occur. Remove paper from bottom
of dishwasher.
If brackets cannot be attached to
countertop, attach dishwasher
to
floor using l/4" lag bolts through
hole in each side of dishwasher
frame.
, equally
spaced,
Open door approximately
3" and check for equal
spacing between inner door and tub
sides. If necessary, loosen screws
that fasten dishwasher
to countertop
and shift tub. Retighten screws.
Place level against
interior flange as
shown. Level dishwasher
front to
back and side to side by adjusting
leveling legs.