Avantco 360CRR2HCW Kullanıcı Kılavuzu - Sayfa 7

Buzdolabı Avantco 360CRR2HCW için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Avantco 360CRR2HCW 7 sayfaları. Glass countertop merchandiser refrigerator

Sayfayı Yazdır

Troubleshooting

Problem

Possible Cause

Fuse blown or circuit breaker tripped.

Power cord unplugged.

Compressor not running.

Thermostat set too high.

Cabinet in defrost cycle.

Excessive amount of warm product

placed in cabinet.

Prolonged door opening or door ajar.

Condensing units run for

long periods of time.

Dirty condenser coil.

Evaporator coil iced over.

Thermostat set too warm.

Airflow blocked.

Excessive amount of warm product

placed in cabinet.

Cabinet temperature is

Fuse blown or circuit breaker tripped.

too warm.

Dirty condenser coil.

Evaporator coil iced over.

Low refrigerant levels.

Door is slightly ajar.

Condensation is

collecting on the cabinet

Relative humidity is above 55%.

and/or floor.

Poor switch connection.

Interior light is not

Bulb is not connected.

working.

Bulb has burned out.

Product on the shelves is over the

Case isn't rotating

weight limit (22 lb.).

User Manual

Glass Countertop Merchandiser Refrigerator

Possible Solution

Replace fuse or reset circuit breaker.

Plug in power cord.

Set thermostat to lower temperature.

Wait for defrost cycle to finish.

Allow adequate time for product to cool down.

Ensure doors are closed when not in use. Avoid opening door for

long periods of time.

Clean the condenser coil. (Page 6)

Unplug unit and allow coil to defrost. Make sure thermostat is not

set too cold. Ensure that door gasket is sealing properly.

Set thermostat to lower temperature.

Re-arrange product to allow for proper air flow. Make sure there is

at least four inches of clearance from evaporator.

Allow adequate time for product to cool down.

Replace fuse or reset circuit breaker.

Clean the condenser coil. (Page 6)

Ensure door is closed when not in use. Avoid opening door for long

periods of time.

Contact a service technician to check refrigerant levels.

Make sure door is completely closed.

Move unit to area below relative humidity or lower humidity level.

Turn off light switch and turn it back on.

Make sure the bulb is correctly inserted in the socket.

Replace the bulb.

Remove some product from the shelves.