HIKVISION U1T Series Kullanıcı Kılavuzu - Sayfa 7
Güvenlik Kamerası HIKVISION U1T Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. HIKVISION U1T Series 16 sayfaları. Turbo hd turret & dome camera
Ayrıca HIKVISION U1T Series için: Kullanıcı Kılavuzu (15 sayfalar)
Sayfayı Yazdır
7. Align the camera with the mounting base, and tighten
the screws to secure the camera on the mounting
base.
Figure 2-4 Secure the Camera with Mounting Base
8. Connect the corresponding cables, such as power
cord, and video cable.
9. Power on the camera to check whether the image on
the monitor is gotten from the optimum angle. If not,
adjust the camera according to the figure below to get
an optimum angle.
Pan Position
[0° to 360°]
1). Hold the camera body and rotate the enclosure to
adjust the pan position [0° to 360°].
2). Move the camera body up and down to adjust the
tilt position [0° to 75°].
3). Rotate the camera body to adjust the rotation
position [0° to 360°].
2.2 Installation of Type II Camera
Before you start:
Both wall mounting and ceiling mounting are suitable for
the turret camera. Ceiling mounting will be taken as an
example in this section. You can take steps of ceiling
mounting as the reference, when adopting the wall
mounting.
Steps:
1. Disassemble the turret camera by rotating the camera
to align the notch to one of the marks, as shown in the
figure below.
2. Remove the mounting base from the camera body
with a flat object, e.g., a coin.
3. Paste the drill template (supplied) to the place where
you want to install the camera.
4. Drill the screw holes according to the drill template,
and the cable hole (optional) on the ceiling.
Tilt Position
[0°to 75°]
Figure 2-5 3-axis Adjustment
Mark
Notch
Figure 2-6 Disassemble the Camera
Rotation Position
[0°to 360°]