KitchenAid KDS-40 Kurulum Talimatları Kılavuzu - Sayfa 2
Bulaşık Makinesi KitchenAid KDS-40 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. KitchenAid KDS-40 6 sayfaları. Dishwasher-sink combination
IMPORTANT:
Read
Before
Installing
to Save Time,
Work,
assure
proper
performance,
and
owner's
warranty
protection.
ELECTRICAL
SPECIFICATIONS
CAUTION:
Avoid
getting
joint
compound
Voltage & Frequency
---
115 volts-60
hertz
inside
new
joints.
Hot
water
fill
line
must
be
Operating
load
-------
13.5 amperes,
flushed
of
foreign
matter
before
connection
to
Maximum
Fuse Size ----
15 amperes
dishwasher
fill
valve. A hand shut off
valve (not
furnished)
should
be located
in an easily accessible
Wiring
must
conform
to local
code and/or
Nat.
area adjacent to the dishwasher.
Electrical
Code.
Plumbing
must conform
to local code. Use l/2"
O.D.
ature at dishwasher
should
be 120"
F. or higher. A
(min.)
copper
tube for water
line. Dishwasher
has
5/8"
I.D. drain hose is furnished
for connection
to an
318"
I.P.S.
Internal
thread
at
valve.
A
90"
air gap, waste disposer or the Drain "T."
Drain "T"
is
compression
ell
(furnished)
should
be
used
to
furnished.
Air Gap and Rinse Agent Kit accessories, if
connect
tubing
to
valve,
Water
flow
pressure
at
required,
are available
from
your
dealer or distrib-
dishwasher
to be 20 PSI to 120 PSI. Water temper-
utor.
INSTALLATION INSTRUCTIONS
0
1
The lower front
panel must be removed to enable plumbing
and electrical
connections
to be made. To remove
lower
panel, take out two
screws
(C) and lock washer (D).
With
index fingers, push support
tabs (B) up, and pull bottom
of
lower panel outward
to clear tabs of kickboard.
Slide lower
panel down until side flanges are clear of evaporation
channel
support
(A). Reverse procedure
when replacing
lower panel.
FIG. 1
0
2
To establish
a reference
line for purposes of
providing
plumbing
and electrical
connections
to the dishwasher,
measure 21" from the wall.
(This
is the front
edge of dishwasher
kick
panel. There is a 3" toe space from the front
of the kick
panel to the front
edge of the
dishwasher
with
a
standard
metal
front
panel).
For corner installation,
allow 2" clear-
ance for adjacent cabinet.
SHADED AREA SHOULD
BE FREE
OF ALL PLUMBING
AND ELECTRICAL CONNECTIONS
ROUGH-IN
OR
FIG.
2
REFERENCE LINE